Grab the front of the seat cushion and pull straight up.
There are two spring clips that hold it down.
Then at the base of the backrest,there are bolts that hold it in place.
The battery is under the rear seat cushion. # Push in and up on the front of the rear seat cushion. # Lift up and out on the seat cushion. # Remove the rear seat cushion from the vehicle
Right side (passenger side) under the cushion of the rear seat. Remove the rear cushion - there are access port covers. Remove the covers and there is the pump.
If you remove the rear seat cushion and then the seat back, you can access the clips holding the package shelf and remove them. The speakers are held in with four screws each that have to be removed. It's only about an hour job.there are several "clips" holding the carpet down behind the rear seats. they can be accessed through the trunk and then the whole piece will lift out and the speakers can be removed.
behind the drivers side rear tire on the frame
Remove the bolts fastening the rear seat cushion (Figure 7.52).Remove the rear seat cushion assembly.Remove the screws and remove the side rear seat back (Figure 7.53).Remove the lower bolts fastening the rear seat back.Tightening torque - 17-26 NmFlip forward the rear seat back, remove the bolts and remove the back seat.Tightening torque - 17-26 Nm
The seat track is bolted to the floorboard. ANSWER: my 2001 Taurus had clips for the rear seat cushion where if you push the cusion twords the rear of the car then pull upward the cushion should come off...
With reasonable force, lift the cushion from the front and bottom - about one foot from both ends.
Under the rear seat. Pull two tabs and lift out the seat. Remove two screws in panel to access the sending unit.
how would you remove the rear speakers to a cadillac sedan deville 1990.
Rear Speakers 1. Push the 3 buttons under the rear seat cushions on the right, center, and left side. Remove rear seat cushion. 2.Remove side arm bolts on both side of the car left and right, you should be able to find the bolts on the bottom of the arm cushion. 3. Once removed, if you look on the side of the rear back support cushion, their is a bolt holding the cushions in place on both sides, remove the bolts. 4. Then you should be able to remove the rear trim panel so that you can remove the screws/bolts that's holding the rear speakers in place.
* Working at the front of each seat cushion push the retaining tabs in then lift up on the front edge of the cushion and release the seat cushion retaining tabs. Remove the cushion from cushion from the vehicle * Detach the retaining bolts at the lower edge of the seat back * Lift up on the lower edge of the seat back and remove it from the car
Start with the bottom seat cushion of the rear seat Lift the front of the cushion, it will pop free. Once the front of the cushion is free, slide the cushion forward and remove it from the car. After the bottom cushion is removed, you can remove the two 12mm bolts securing the backrest. After removing the two 12mm bolts, slide the backrest up to unlock it and remove it from the car.