The bolts are visible at the base of the seat. Remove them and lift out the seat.
pull up on the front part of the seat
Remove the bolts fastening the rear seat cushion (Figure 7.52).Remove the rear seat cushion assembly.Remove the screws and remove the side rear seat back (Figure 7.53).Remove the lower bolts fastening the rear seat back.Tightening torque - 17-26 NmFlip forward the rear seat back, remove the bolts and remove the back seat.Tightening torque - 17-26 Nm
Under rear seat! right passneger rear seat
The seat track is bolted to the floorboard. ANSWER: my 2001 Taurus had clips for the rear seat cushion where if you push the cusion twords the rear of the car then pull upward the cushion should come off...
Yes it has one, under passenger rear seat. There is a removable panel under the passenger rear seat.
The rear seat is not designed to be removed. You can remove the center seat and slide the rear seat forward.
In my 2000 LeSabre, it's under the back seat. Remove the rear seat and I'll bet it's there.
The rear seat isn't designed to be removed. If you have a center bench seat you can remove that by unclipping it, then slide the rear seat forward.
The rear seat is not intended to be removed. You can remove the center seat and slide the rear on forward into it's place.
How do you remove the rear seat on a 2002 diamante
on a 2002 sportage it's on the left side (passenager side) near the fender above the axle mounted to the bodyanswerDisconnect the negative battery cable. Remove the retainers for the rear seat, then the rear seat cushion. Disconnect the harness connector from the fuel sender.Remove the fuel tank module screws, the fuel sender and the fuel filter.
Remove rear seat and panel underneath seat. How do I remove rear seat?!?!