I assume that you are talking about the seat squab, or base.
There are clips welded to the floor. These clips look a bit like the number 1. They face towards the rear of the car though. Metal loops on the underside of the seat base hook under the top part of the "number 1".
To unclip the base, you have to firmly push the base down and rearwards, then upwards. This sounds harder than it is.
To clip the base back in, you need to carefully line up the loops on the sloping part, at the top of the clips. Then push the base down, firmly. You will feel the loops slide down the slope and then pop under the clip.
The backrests should unbolt. Just flip them forward and you should find bolts under the carpet. Although, you probably wont need to remove these, if fitting seat covers.
The side bolsters are held in place by a bolt at the bottom and by the striker plate, for the backrest lock.
Best of luck.
you rip the seat off with your bare hands. ********************************************************************* On old Fords and many others you push down and back on bottom of the back seat to unhook it then you have 2-3 bolts you can reach to remove the top of the rear seat.
To remove the rear seat from a 1989 Ford Laser 4 door car, first remove the bolts anchoring the rear seat to the floor of the vehicle. Then, lift the bottom portion of the seat from the car. Then, remove the internal bolts from the hatchback or trunk of the car to remove the seat back.
unbolt it.
two nuts from under the body removed the seat track - easy as pie !
remove rear seat and then remove access panel
The rear seat is not designed to be removed. You can remove the center seat and slide the rear seat forward.
Remove the bolts fastening the rear seat cushion (Figure 7.52).Remove the rear seat cushion assembly.Remove the screws and remove the side rear seat back (Figure 7.53).Remove the lower bolts fastening the rear seat back.Tightening torque - 17-26 NmFlip forward the rear seat back, remove the bolts and remove the back seat.Tightening torque - 17-26 Nm
no frame uniboby Yes you have to remove the spot welds holding the roof and rear quarter panels, then remove the rear seat suport and replace the rocker panels as they are stronger than the ones on aq sedan. Then there is the front windshield you can take the ones from a convertable and weld them to the firewall ans dash metal being very carful as this is the basis for all the matching parts of the convertable this can be done as I did it to a mustang /unibody / and have replaced a rear quarter panel and roof on a falcon good luck and be patiant.
The rear seat isn't designed to be removed. If you have a center bench seat you can remove that by unclipping it, then slide the rear seat forward.
The rear seat is not intended to be removed. You can remove the center seat and slide the rear on forward into it's place.
How do you remove the rear seat on a 2002 diamante
Remove rear seat and panel underneath seat. How do I remove rear seat?!?!