Car Stereos and Speakers
Chevy Avalanche
1995-2005 Chevy Cavaliers

How do you remove the rear speakers from 1992 Civic sedan?


Top Answer
User Avatar
Wiki User
Answered 2006-07-19 20:59:58

read up on door panel removal everyone should have a manual for their vehicle, and the library should have a professional manual the reference section, you'll have to make copies of the important sections...good luck :)


Related Questions

The 1992-1995 Honda Civic LX Sedan has a 102 horsepower 16 valve engine called the D1587.


No you cannot put a coupe on a sedan... you should be able to put a hatchback on a coupe or vice-versa.. however sedan is completely different and the body parts are not interchangeable..

you have to remove the whole door panel in order to gain access to the factory speakers in which should be 4x6.

Front speakers are in the door. remove screws on the door panel, then remove the panel and you'll see the speaker

Yes, it's called a saloon or sedan. no a coupe is a 2 door a sedan is a 4 door and yes they do make an ex model

pull out the speaker covers, get a 7mm socket, & remove the 2 screws..

The speed sensor is found on the transmission of the 1992 Honda Civic. To replace the unit locate the mounting bolts and remove them. Unplug the wiring clip and pull the sensor off.

where does the camshaft sensor go in a 1992 Cadillac Sedan Deville?

4" in the dash, and 5" in the rear deck if it's a sedan, or 5"x7" if it's a hatchback. Hope this helps.

Sedan: 1. Remove the retainers from the high mount brake light and lift off the cover. 2. Move the package tray out of the way. 3. Remove the speaker mounting screws. 4. Lift the speaker out and disconnect the electrical connectiions. 5. Installation is the reverse.

In order to remove the speakers, you must remove the "Dash Pad". It's held in place with clips and a couple screws. Start by pushing up in the center of the dash pad. Then remove the screws.

Standard Sedan DeVilles had 6 speakers; two on top of the dash near the windshield, two in the front doors at the front lower corner, and two on the package shelf near the back window.

Remove distributor cap. remove rotor. remove icm shield. remove all wires from icm. remove two screws holding icm. pull icm strait out

Nukes. If nukes are not available, use Dick Cheney's head.

What is the spark plug gap for a 1992 honda civic. .

Changing a light on the instrumental panel requires removing the whole dashboard on a 1992 Honda Civic. Loosen and remove all the dash mounting screws and pull of the dash. Remove the cluster from the display and pull off the old bulb. Install the new bulbs.

Check engine codes on Honda vehicles such as a 1992 Honda Civic have to be manually reset. To do so, remove the ECU fuse located inside the engine bay.


A wiring diagram for the oxygen sensor on the 1992 Civic can be found at your local auto parts store. Haynes sells a manual for the 1992 Civic with a diagram included in it.

front or back speakers? the back speakers, you must remove the rear seat. it is simply held by two bolts on the bottom edge of the seat. once you get them out, there is two torx bolts you must remove. then you will just pick up on the back rest and it will easily come out.

with a screw driver it would help not hard to do use the brain

Civic Alliance of Serbia was created in 1992.

Loosen the screws on the cap and there is a single screw holding the rotor to the shaft

Purchase the following: -OBD2A to OBD1 harness -P28 ECU out of a 1992-1995 Honda Civic EX/Si Have it professionally tuned and have them remove the governor.

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.