answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2014-08-21 08:40:13

To remove the rear view mirror off a 2000 Mitsubishi Mirage first pop off the plastic cover place on the body of the mirror. Than proceed to unscrew the mounting screws.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Your Answer

Related Questions


To remove and install a door mirror on a 2000 Mitsubishi Mirage, the door panel needs to be removed on the inside of the door. First remove any light lenses in the door, then unfasten the clips holding the door panel on. Then remove the mounting bolt for the mirror. Put in a new mirror, replace the door panel and the light lenses.


Como instalar alarma ORIGINAL DE MITSUBISHI MIRAGE 2000 Como instalar alarma ORIGINAL DE MITSUBISHI MIRAGE 2000






The 2000 Mitsubishi IAT sensor can be found on the right side of the engine. The sensor will be just below the head deck.


I need to see a photo pitchure of the timing alighnment marks,for the crank and cam shaft alighnment for a 2001 Mitsubishi mirage 1.8 liter engine




Look on the lower end of engine -- follow + battery cable


Drivers side around the fuel filter area.


Right next to where you put in the oil (Gasket Cover)


Driver's side engine compartment below master cylinder.


Our 1.8 liter is automatic...however, I understand from the parts dealer I go to often says that year can come auto OR standard. I have seen a Galant from 2000 that was standard. Hope this helps. i have a 2000 mirage and it is a standard.



1.8L engine is 4Cyl 4G93 1.5L engine is 4Cyl 4G15


below the steering wheel on the right side for the 1.8 for 1.5 im not sure.


A 2.0 from a lancer fits and bolts up in same spots


Remove the set screw from the mirror, slide off.



You can get a key from the manufacturer with the vin number, or you can go to a locksmith and it can be ordered using the vin number.


Remove speaker grill, remove screw holding speaker, screws to the mirror are behind speaker


how to remove a passenger side mirror on a 2000 toyota 4 runner


The Back up light switch (reverse light switch) is located on the top of the transmission. If you remove the air cleaner element, look down, a little to the left you will be able to see it.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.