you squeeze the tabs in the middle gently inwards then pull the cover toward the front of the car.the brake light housing itself has a tab on either side of it that you need to press to remove the light .
i believe that the antenna for these cars are on the rear window - the two vertical lines that are near the window brake light.
In the top of the trunk near where the brake light is located, there is a small plastic window, remove it and you access the light bulb.
How do i change the 3rd brake light on a mercedes vito van.It is the brake light above the back door?
Remove your 1998 Honda rear window brake light cover. Push the light bald in and turn at the same time. The light bulb will come out. Reverse the process to install the new light bulb.
if the high mounted brake light is in rear window. open trunk and access the light from below rear window shelf. if the light is in the spoiler, remove the screws holding it in. disconnect elec, connector from inside of trunk lid. the assembly has no replaceable bulbs, and has to be replaced as a unit..
more information needed is it in the window or the design in the spoiler
Get in the back seat and grab the rear brake lite and pull the cover toward you. Bulbs are then remove able.
Where is right brake light fuse on a 1999 Mercedes E320? Thank you.
remove the sensors and clean it. then put it back. if the warning light is still replace the sensors it is cheap
The brake light switch is located on the brake pedal assembly. 1. Remove the cover below the instrument panel 2. Remove the electrical connector. 3. On the switch their is a locking tab the prevents rotation. Press the "tab" and rotate the switch 90 degrees. 4. Remove switch.
You will need to remove the 1998 Chevy Camaro brake light wiring harness. Remove the brake light retaining screws. Reverse the process to install the new brake light.
From inside the trunk.