The brake light switch is located on the brake pedal assembly.
1. Remove the cover below the instrument panel
2. Remove the electrical connector.
3. On the switch their is a locking tab the prevents rotation. Press the "tab" and rotate the switch 90 degrees.
4. Remove switch.
Where is the brake switch in Mercedes Benz E320, 1999 located? How do I replace it?
I am not sure but there should be a switch by the brake pad to release the safety neutral switch to allow you to shift. Try that.
How do i change the 3rd brake light on a mercedes vito van.It is the brake light above the back door?
Remove the Mercedes-Benz wheel and tire. Remove the brake pad and hardware. The brake pads will come off. Reverse the process to install the new brake pads.
Brake light switch near brake pedal
Remove the tire and wheel from your 1986 Mercedes-Benz 420. Remove the brake pad spring and caliper. Reverse the process to install the new front brake pads.
bulbs or maybe your brake light switch is bad. otherwise, not sure.
Switch loose or faulty? Check if the switch is fitted to the brake pedal. Perhaps the bracket has worked loose.
four pin
Just pull the gear that is under the light switch on the left hand side under the steering wheel that looks like this ((P)).
a mis adjusted brake light switch could cause that fault.
Try spraying the brake light switch with WD-40 first. If that doesn't fix the situation, then: . Remove the under-dash panel. . Locate the switch near the top of the brake pedal and disconnect the wiring harness. . Remove the switch retaining pin and the white nylon washer from the brake pedal pin, then slide the brake light switch and pushrod off far enough for the outer hole of the switch to clear the pin. . Slide the switch down to remove it.