Want this question answered?
A bumper grille is the lower piece of grille insert right below the upper main grille insert. It may also be called an air dam grille insert. People who purchase upper main grilles often also purchase the bumper grille in order to achieve a more consistent look for their car. Please see http://www.automaxstyling.com/aps-aluminum-billet-grille-lower-bumper-bolt-over-horizontal-billet-1797/?year=2&make=302&model=4845&submodel=20507 for what a bumper grille looks like.
Were do i insert coolant in my c320 2001 mercedes
There is a tool with your jack that you insert through the hole in the bumper and turn to lower the spare
carefully putting the WA 2000 into the engine
depends on the type of car but most newer cars have a hole in rear bumper to insert the jack handle and crank down the spare
The position light cover pops out or rather swings out, after you gently insert a small screwdriver into the slot and give a pry. Easy.
you have to insert a paper clip in the hole on the black cylinder cover and unscrew the cover, good luck
Insert the key, turn it all the way to the left, push the lock in and open the lid. Do the opposite to lock it.
If I recall, that year, the SS emblem on the rear of that car, comes via a black rubber insert, on the pass side of the car, which bolts to the bumper.
You insert a screwdriver into the bottom of it and pry it open. It does not come off, but hinges open, allowing you to insert the jack. If you don't have a screwdriver, there is a tool in the toolbag that comes with the car, usually located inside of the spare wheel.
Disconnect the negative cable. Remove any screw from the switch. Slide the switch from the dash. Remove the switch and insert the new switch.
Look for the hex socket bar under the seat. Find the hole through the rear bumper and insert the socketbend of the bar. With the ratcheting handle, turn to lower the spare.