was this answered becuase i need to know too
Remove the bolt in the lever perch. For a clutch lever, loosen the cable enough to remove the broken lever and replace the new one. Adjust the clutch cable back and replace the bolt in perch. For the brake (disc brake)) lever, you simply remove the bolt and replace lever, put the bolt back in the perch and you're done. If you have drum brakes, it is the same as the clutch lever routine.
Replace the lever with a new or good used one.
To open the hood on the 2000 Beetle if the hood release lever is broken inside the car, you can remove the glove compartment of the vehicle and find the release cable inside the dashboard. Pull the cable to open the hood. You will then need to replace the hood release lever.?æ
loosen the bolt on the lever, remove the lever and replace in the new angle, then retighten.
I believe tyhere was a recall on this. check with dealer
it is not the fuse it is a broken wire. Replace the shift lever.
The headlight dimmer switch is located on the end of the lever. Remove the steering column so the lever can be properly reached.
To replace a break lever on your bike, you must first remove the old brake lever, located on the handlebar. This may require you to temporarily remove the gripper and the gear shifter, allowing you easy access to the brake lever. After loosening the hex bolt that attaches the brake lever to the handlebar, the lever should slide right off. You will then want to remove the brake cable and the cable housing from the lever. Put the new brake level onto the handlebar, being sure to match it to the one on the other side. Tighten the lever with the hex bolt, and reattach the cable housing to the lever. Test the brake to make sure it is satisfactory, making adjustments as needed, and then reattach the gear shifter and gripper.
dimmer switch is on the turn signal lever, to replace you need to remove steering wheel
You will remove the engine then you replace the clutch plate on the flywheel, You also will have to remove the bearing which sits in the bell housing, and then put it back together again.
its the fastener to a cam lever. this is what was thought to have snapped off in foul weather, resulting in the sinking of the Edmund Fitzgerald
probably because the wire is broken at the bottom of the shifter lever and you have to replace the whole shifter lever.