If you have the 2.2 liter engine, there are two (2) bolts that hold the cover on the top of the engine. These bolts will require a hex head (Allen wrench) to remove and tighten. Remove these bolts, lift the plastic cover up, and you will see the four spark plug wires leading to each spark plug. Twist and then pull straight up (you may have a plastic hook on each wire) to remove the wire. Then you can use a 5/8" spark plug wrench with a long (6") extension to remove and replace each spark plug.
remove timing cover remove oil pan and oil pick up pull timing belt and replace oil pump and gasket. reinstall
breather pipes.
it could ruin your engine, to were it is unfix-able :(
The water pump is under the timing belt cover on the passenger side.
They are under the cover on top of the engine it just has two bolts holding it.
The oil pump is in the oil pan at the bottom left 'front' of the engine. (Note: The 'front' of the engine is on the passenger side. ) To replace it you will need to remove the catalytic converter, some exhaust piping, the oil pan, the valve cover, the timing chain and timing chain cover. It is bolted to the engine block just above the crankshaft gear.
Remove the 4 screws holding the top cover. You can then get to the plug wires and the plugs.
Remove the the plastic cover on the valve cover, next remove the coil,or spark plug boot. Then you have access to the spark plugs. Make sure you gap your spark plugs,before you install them. If your not sure, it's wise to do them one at a time. After the replacement, do everything in reverse order.
For DOHC engines its located under the sparks plugs cover near the camshaft sprocket.salehanzi@yahoo.com
take off the valve cover put on new gasket then put cover back on you if you cant figure it out you should be hit in the head with a tact hammer.
remove timing cover
depends on whether or not the belt has snapped,if not £250.00 should cover it,if it has then it depends on the amount of engine damage caused.