Get a 5/8" spark plug socket, socket wrench, and if you can a spark plug wire removal pliers. The spark plugs are located on the sides of the engine, between the exhaust manifold. Remove the wire covering the spark plug be careful ,don't just pull on it, first turn it, from side to side, using the pliers. Due to the heat the wire bonds with the spark plug and easy to tear them. So first twist them and then pull. Make sure you pull close to the end. Insert the socket on the spark plug and turn counter clockwise. Before you install the new plug, check the gap. Insert the new plug in the socket and turn it with your fingers three-to four turns is good. Make sure you turn in with your fingers first is very easy to damage the threat if you use the socket wrench. Once you feel the plug has gone straight into the thread use the socket wrench to tighten it. Its the same procedure for the rest of them.
Remove the spark plug wires from your 2000 Chevy Impala spark plugs. Remove the spark plugs with a 5/8 deep well socket by turning the socket to the left. Reverse the process to install the new spark plugs.
With a wrench!!
Disconnect the battery, remove the spark plug covers and cable, and remove the old spark plugs. Put in the new spark plugs, replace the covers and cable, and reconnect the battery.
You unplug, unbolt and remove the coils. The plugs are under the coils.
you push in the wire after turning of the plug yhen get some pluers and get it out
Disconnect the battery, remove the spark plug cables and boot covers, and remove the old spark plugs. Properly dispose of the old spark plugs. Next, put in the new spark plugs, reattach the spark plug boot covers and spark plug cables and reconnect the battery.
Disconnect the battery cables, remove the spark plug cables and covers, remove and dispose of the old spark plugs. Next, put in the new spark plugs, attach the covers and cables and reconnect the battery.
Lift the hood, disconnect the battery, remove the spark plug cables and covers, and remove the old spark plugs. Next put in the new spark plugs, replace the cables and covers, reconnect the battery and close the hood.
You have to remove the upper intake manifold.
Remove the coil on top of the plug. There's the spark plug.
You have to remove the upper intake manifold.
The left side spark plugs are under the pop-off engine cover. Remove the coils and the spark plugs are right there. The right side plugs are in the same location on the other side of the engine...unfortunately you must remove the intake manifold to access them.