there is a screw under the "Honda" emblem covering the speaker grill. the emblem itself has a tiny cutout/notch on the right side that you put a small flat-head screwdriver and push inward toward where it says "Honda". it basically has 2 clips on each side but compressing one allows access.
after that unscrew the speaker grill, and then unscrew the 4 screws holding the speaker in place.
and that's it!
note: if you mix the plug wires up when you take the speaker out, the positive wire has the line on it.. also the right speaker's cord feeds all the way through to the left side, so you should disconnect it at the speaker end because it is a pain to feed it back through the fairing.
interstate 700 lbs dry to 750lbs wet.
what size is the original tires on a 1986 goldwing? what size is the original tires on a 1986 goldwing?
Remove the seat and the top compartment. It's under the air filter.
Remove the lower ( part of the fairing ) on the left side, ( clutch side ) its in there.
Remove the right hand pocket on the fairing ( hand brake side ) it's in there.
how to change oil in a 1986 honda gold wing motorcycle
If this is still the same as up to 1986, then you have to remove the left side exhaust, left side crash bar, gear shift, and removable sub frame. Theres your starter. Good luck.
The '84 and '86 are the same. If you have the carb. version, why not. It's a manual cruise.
400 lbs for total weight.
Should be on the steering, below the tank.
1 down and 4 up. The neutral is in between 1st and 2nd.
the front speakers are 4"x6" the rear speakers are 3-1/2"