The starter is in between the intake and the transmission, it is a very tight fit and very difficult to remove. The first thing to do is disconnect the battery and then safely jack the car up. Climb under the car and reach up over the transmission and remove the wires first. There should be a gap between the transmission and the engine that you can see thru. After the wires are off, remove the bottom bolt with a size 13 deep socket, it is very slow going one click of the ratchet at a time. Once the ratchet stops ratcheting on its own use a long screw driver in the other hand to press against the socket to maintain the ratcheting action. There is no way to get your hand up there so everything has to be done with the ratchet. After the bottom bolt is off its time to move to the top bolt. The top bolt can be much more difficult and is accessed from under the hood. Recommend using a ratcheting wrench due to lack of space. There is a lot of wires and coolant lines in the way that make it extremely difficult to remove. Again this bolt will be very slow going. After the top bolt is off remove the starter from under the vehicle, this can also be a challenge just be patient and you'll get it. This is not an easy fix on a Daewoo, 3-5 hours should be set aside just for removal and another 3-5 for installation.
The back side of the motor below the intake and coolant bypass tube
Hi, here is a pic of a 1999 Daewoo Lanos Motor Regards Pacnat1
How much oil a Daewoo Lanos SE 1998 is used to change the oil in the motor
IT is an INTERFERENCE engine.
Hi, Disconnet the battery cables from the battery. Disconnest the battery cable from the back of the Starter motor, and the other red wire., then undo the two bolts holding the starter motor in place one on top and one below the starter motor., withdraw the starter motor from the motor and remove from the car, Installation is the reverse of the dissassembly instructions. Hope this helps
how do i remove the starter motor Mazda rx8
On a 2000 (not sure 01 is the same or not), it is located uner the dah on the passengers side. Held on by 4 (I believe) bolts and sensor connector. Remove the bolts and attached wiring. Blower should remove easily.
It has a 6 cylinder motor also known as a V6 I do not think it can run only on 3 cylinders.
how to remove starter motor on bmw 745
how to remove starter motor for Peugeot 206 1.4 hdi.
How do i remove an Audi A6 Starter motor
disconnect battery. from underneath disconnect solenoid wire and battery cable from starter solenoid. remove starter motor bolts. remove starter motor. installation is the reverse but be sure to place the starter shim between the starter motor and the engine or you will get noise during starts.