answersLogoWhite

0


Best Answer

On a 2000 (not sure 01 is the same or not), it is located uner the dah on the passengers side. Held on by 4 (I believe) bolts and sensor connector. Remove the bolts and attached wiring. Blower should remove easily.

User Avatar

Wiki User

8y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace the blower motor for a 2001 Daewoo Lanos?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Are there any pictures of Daewoo lanos engine?

Hi, here is a pic of a 1999 Daewoo Lanos Motor Regards Pacnat1


How much oil to put in a Daewoo lanos?

How much oil a Daewoo Lanos SE 1998 is used to change the oil in the motor


Does the 2001 Daewoo Lanos have a interference or non-interference motor?

IT is an INTERFERENCE engine.


Where is the blower motor on a Daewoo Leganza?

Behind the glovebox .


Where is the location for the starter motor on a Daewoo lanos?

The back side of the motor below the intake and coolant bypass tube


How do you replace blower motor on 2003 Ford Focus?

at is the cost to replace a blower motor on a ford focus


If the blower stopped working my 2001 Kia Spectra could this be the motor blower resistor or should I replace the blower motor?

Check to see if you are getting power to blower motor - if so replace blower motor If not check fuse, switch, resistor pack.


Blower motor resister blows out 2002 fordfocus?

Replace the blower motor also.


How do you replace the blower motor on a 1994 Chevy lumina euro?

How do you replace the blower motor on a 1994 chevy lumina euro?


Where is blower motor on 2001 Chevy blazer motor and how do you replace it?

where is the blower motor on a 2001 chevy blazer


How do you replace motor blower on vauxhall vectra 2003?

How do you take out a blower motor on a vauxhallvectra vectra


How do you replace blower motor for a 2006 Chevrolet coloardo?

To replace a blower motor in a 2006 Chevrolet Colorado first remove the old blower motor. Then install the new motor making sure to connect all the wires.