Starters and Ignition Systems
Pontiac Sunfire
Chevy Blazer S-10
1982-1994 Chevy Cavaliers

How do you remove the starter off a 1999 Sunfire?

222324

Top Answer
User Avatar
Wiki User
Answered
2007-04-23 18:06:55
2007-04-23 18:06:55

in order to do this is simply easy first locate the starter on my 99 sunfire it is under the engine near the fan so you gotta get under the car and just simply take the nuts and bolts off and remember which one goes where for when u put the new one on... hope it helped some

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


One way to know, is to check the part number for each starter on one of the big parts houses' websites. If they are the same, odds are it will fit.

Remove the cables from the starter. Remove the starter retaining bolts. The starter will come off. Reverse the process to install the new starter.

You can remove the starter clutch by removing the entire starter. Take the front cover off of the starter. Remove the clutch using a gear puller.

Remove the starter cables. Remove the retaining bolts. The starter will come off. Reverse the process to install the new starter.

Remove the battery cables from the starter. Remove the retaining bolts from the starter. The starter will come off. Reverse the process to install the new starter.

Remove the battery cable from the positive post of the battery. Remove the cables from the starter. Remove the starter retaining bolts. The starter will come off. Reverse the process to install the new starter.

Remove the starter cables. Remove the starter retaining bolts. The starter will come off. Reverse the process to install the new starter.

disconnect battery or connection to starter and take it off.

Remove the positive cable from the battery posts. Remove the cables from the starter. Remove the starter retaining bolts. The old starter will come off. Reverse the process to install the new starter.

remove wires from the top of starter, remove the two bolts that attach starter to bell housing, pull starter off, reverse to put starter back on

very hard! I just finished retapping the cam housing bolt holes in my 2000 sunfire. but had to remove the timing chain to get the cam cover and housing off. to get the timing chain off, you have to remove the motor mount bracket off first, then remove the timing cover before getting to the chain. no room to get the bracket bolts off without some assistance to pry the engine to the opposite side.

Remove the cable wires from the starter. Remove the retaining bolts. The starter should come off. You may need to tap on the starter with a hammer to loosen it.

Remove the positive cable from the battery, to reduce the risk of a shock. Remove the cables from the starter. Remove the retaining bolts from the starter. The starter will come off. Reverse the process to install the new starter.

The starter solenoid can be replaced by removing the wiring harness. Remove the retaining nuts. The solenoid will come off. Reverse the process to install the new solenoid.

Disconnect the battery, take off the terminals on the starter, then remove the starter mounting bolts in the belt housing.

Remove the positive battery cable from your 1997 Dodge Grand Caravan battery. Remove the cables from the starter. Remove the retaining bolts from the starter. The starter will come off.

Begin by removing the positive cable from your 1993 Chevy Camaro battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. The starter will come off.

pull the wheel off, remove the two caliper bolts, remove the caliper and the rotor can be removed

Replace Remove starter Remove solenoid at top of starter Remove front end of starter for access Remove locking washer from starter shaft Drive should slide off shaft

Disconnect the - battery terminal Raise and support vehicle if necessary remove wiring from top of starter Remove mounting bolts Remove starter

The center console is held on by several mounting screws. To remove it from a Pontiac Sunfire unscrew all of the mounting hardware. The center console will then be able to be pried off.

Hi I have just finished installing a B&M short shifter in my 02 sunfire gt and I had to cut it off (its made out of a very dense foam)To get the nob off, to remove the cup bushing retainer.

Remove the two bolts holding the starter to the engine then you should be able to drop the starter down enough to take the wires off and remove the starter.

Disconnect the battery Raise the vehicle Remove the two nuts on the starter to get the wires off 10 mm and 13 mm Remove the two bolts holding the starter to the engine block and remove the starter

how do you take a starter motor off of a 1999 nissan primera auto


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.