Open the liftgate. Look at the tail light assembly and you should see two screws on the side facing the middle of the car.
Remove the two screws and the whole assembly drops out. Replacing is the reverse of removal.
If I remember correctly, you need a size 15 Tor-X screwdriver (it may be a Phillips head, but I doubt it)
how do you remove ash tray assy in 97 pontaic grand prix gtp sc
Remove wheel. Remove Brake assy. Remove two screws on rotor. Remove Rotor. Replace Rotor. Tighten Screws. Reinstall Brake assy. Reinstall wheel.
remove the side marker light assy Phillips screws, the assy will slide out. you then have access to the three 10mm bolts holding the fog light assy in. remove then and push out the fog light assy. then remove the four Phillips screws from the corners of the fog light to separate the assy. then change the bulb and put back together
I tried to replace the Bulb in my 2003 Corolla but I couldn't get to the bulb how do you unscrew the rear light assy.
Take a hammer. smash the headlight assy. lens. Remove old bulb, put in new.
same as left sider, remove bulb from assy, after removing ass'y.Answersame as left sider, remove bulb from assy, after removing ass'y.Answersame as left sider, remove bulb from assy, after removing ass'y.Answersame as left sider, remove bulb from assy, after removing ass'y.========================================================Since the answer above is of no help :I'm assuming it would be like my 1995 Ford Explorer- open the liftgate- remove the 2 screws at the top of the rear tail light lense- there are plastic pins ( >>>>>>>> ) that are also used to hold the lense in place so carefully work the lense STRAIGHT back so that you don't break the plastic pins- the bulb(s) sockets are a simple twist to release , reverse to install
the sensor is part of the fuel pump assy and comes out through a hole underneath the matting in the trunk.... remove the cover and remove lines from assy and then remove assy from tank.....make sure to relieve pressure from fuel lines before you remove lines due to residual pressure in the lines...
There is an orifice in the primer assy. in the carb. that is plugged. You will have to remove and clean the primer assy.
I believe the handle is one whole assy handle holder and lever. remove door panel and assy should rivet/bolt to door
when i removed the heater for my nova i had to disconnect the cables and wires from the heater assy and on the engine side of the firewall remove the nuts holding the assy to the firewall that allowed the whole assy to come out from under the dash then i dissassembled the assy and the heater core was bolted into the assy on the ends hope this helps
I have a 92 PA. I had to remove the head light assy which gave access to that bulb. There are two thumb like screws to remove that assy. Hope yours are the same as mine.
there is a nut on the left side of the light on drivers side,just the opposite on passenger side. you will need a deep socket. there are 2 10mm bolts on top of the assy. and on the back is a 10mm nut you will have to remove on order to remove the assy.