The rear shock spring will need to be compressed with a spring compressor. When the spring is compressed the top nut can easily be removed.
remove upper bolt shock remove swing arm nut, remove rear brake master cylinder, remove chain
I found it easier to remove the back seats, disconnect the connections on the top of each shock, jack up each side, remove the wheel, the rest is common sense, remove the bolts and reverse to install.
Jack up the rear of the car, unless you can put it on a lift, remove shock mount bolts, remove shock, and replace
The 1997 Land Rover Discovery shock and Sobers are held in place with a retaining bolt on each end of the shock. Remove the retaining bolts and the shock will come off. Reverse the process to install the new shock absorbers.
There are ( shock absorbers ) on a 1997 Ford Aerostar ( front and rear )
open the trunk look on the lift and the right side in the trunk at the back there a shock tower there a nut to remove. under the rear wheels there a nut remove it .
The strut and coil spring need to be removed from the vehicle to replace the mount. Place the rear of the vehicle on jack stands. Take off your rear wheels. Remove the plastic cover on the top of the rear wheel well from the inside of the back of the vehicle. Remove the three small nuts, NOT the large one in the middle. Remove the sway bar link from the shock. Remove the brake line clip from the shock. Remove the speed sensor clip from the shock. Remove the two bolts from the bottom of the shock. You can now remove the shock. With a spring compressor, compress the spring until you can wiggle the mount. Remove the large nut from the center of the mount. Remove the spacer that is under the nut. You can now remove the bad strut mount.
The rear door panel is held in place by eight retaining clips into screws. Remove the screws near the door handle. Pry outward on each retaining clip. The rear door panel will come off.
You need to remove the rear seat, then remove the package tray.
The 1999 Toyota does not have rear struts. The automobile has rear shocks. Remove the retaining bolts from each end of the shock. Reverse the process to install the new shock.
The 1999 Toyota does not have rear struts. The automobile has rear shocks. Remove the retaining bolts from each end of the shock. Reverse the process to install the new shock.
remove the two upper mounting bolts inside the trunk, then remove the one on the axl, replace bolts when you replace the shock...