You can't. It is computer controlled. Actually, that's not necessarily true.... All you need is a Chilton's manual to trace the location of the vehicle speed sensor (VSS) wire, which goes to your ECM. Find the wire, clip it and splice in a toggle switch to your dashboard, then run the wire back to the other side of the wire you snipped. Switch off, the VSS is disabled and probably, you will get a computer code or some check engine light that will come on. No big deal, after you do the dirty deed of speeding above and beyond what all of us disapprove of, just switch your toggle back on and POOF! Your VSS works again! (Sorry boys, I'm a gearhead...) Steelman1196 you need to buy a programmer from hypertech. you can get rid of a governor, adjust you're timing, adjust you're speedo for different size tire, regulate the fuel/air .....ect. 20-30 extra horses! depending nick Actually, that's not necessarily true.... All you need is a Chilton's manual to trace the location of the vehicle speed sensor (VSS) wire, which goes to your ECM. Find the wire, clip it and splice in a toggle switch to your dashboard, then run the wire back to the other side of the wire you snipped. Switch off, the VSS is disabled and probably, you will get a computer code or some check engine light that will come on. No big deal, after you do the dirty deed of speeding above and beyond what all of us disapprove of, just switch your toggle back on and POOF! Your VSS works again! (Sorry boys, I'm a gearhead...) Steelman1196
I think it's possible, it depends on the system it has fitted. F body GMC stuff like camaros etc can be overridden, it's a matter of finding the speed sensor circuit and fitting an inline on/off switch. you cannot permanently disconnect it as it will show a fault light and mess up the gearshift speeds
u have to get a performance chip it will diasble the top speed limiter
I don't believe the 4 cylinder has a rev limiter, but if you have the V6 then you would probably have to hook it up to a computer/programmer and disable the rev limiter/fuel cutoff.
It is not recommended by the manufacturer to remove the speed limiter on a Fiat Doblo. The speed limiter is installed for the safety of the vehicle operator.
Replace your CDI
It is controlled by the ECU, which you cannot remove.
95 mph.
DO you know what the top speed of this car is?
yes the top speed of a 1994 buick skylark is 112mph it has a rev limiter or what most people call it a governer.
I heard some people remove a fuse which will kill many things including the speed limiter but that isn't really safe. The better solution is to get a unichip which would in the same time add some horsepower as well as removing the speed limiter
How can you get to the tcc sensor on a 2000 buick lesabre 3.8 and can a speed sensor trigger a code for the tcc
You have to reprogramme the motor's ECU.
buy a SLD speed limit defender.. wire in job....
There is no governor on a any 80's vehicle
The resitor is probably burnt out on the high mode