I have a VW Golf 2003 made in Brazil, to remove the door upholstery you need to pry out very carefully the cover on the door pull handle. There is a seam where you can insert a thin bladed screwdriver and pry this out gently. There are two snaps along the middle, be careful not to break them. With that part out you can remove the screws holding the door handle. With that removed unscrew two screws at the bottom of the door. These may be the kind that require Torx wrenches (they are in mine) Remove small Phillips head screw that is on the inside of the door, holding the upholstery, about level with the rear view mirror on the door jamb. Then insert a thin bladed screwdriver along the edge of the door upholstery and pry out very gently the snaps that hold the rest of the side panel. This should get you where you need to go.Be careful with the wiring.
Begin by removing the inside door panel. Remove the wiring harness from the electric window regulator. Remove the window regulator retaining screws.
The panel where the regulator is detachable. You will be able to remove it very easily. When you remove the panel you will see the way how the regulator can be replaced.
To remove the rear window regulator on a 1994 town car, remove the screws under the arm rest. Take off the rubber insulation and unplug the speaker wires to get it our of the way. Finally, remove the window regulator.Ê
if manual, window regulator. if electric, check fuses, window switch, window motor, window regulator.
To install a new window regulator on a MGRZ driver's door, remove the door panel and the wiring attached to the power window mechanism. Remove stereo speaker from the inside door and the window glass. Remove the old window regulator and replace with new.
1 open door 2 remove inner panel 3 lower window 4 take out window 5 remove (4) screws from regulator 6 take regulator of rails
It is best to replace entire regulator as one unit. Remove door panel. Remove bottom nut of regulator, and remove two top nuts of regulator. Loosen two bolts on bracket holding window. Support window, and carefully remove regulator as one unit.
remove your door panel there will be three screws holding it on. then you have to remove the screws holding your window to the regulator. then unbolt regulator and motor from door. Undo wiring going to motor.
How to remove the window motor from the regulator
Remove the window regulator assembly from the door.Remove the motor from the regulator by drilling out the attaching rivets with a 3/16 in. drill bit.Connect the window motor to the regulator with 3/16 in. rivets.Install the window regulator assembly.
Window regulator controls the up and down motions of your car window. Both electric and manual windows have a window regulator. Not the easiest part to replace, but once you dissembled the door panel it should be fairly simple to replace.
First, lower window approximately half way. This allows you access to the bolts that attach window to the regulator. Remove door panel. Using a 10mm wrench, remove the two bolts that hold window to the regulator. Then there are two upper and two lower bolts holding the regulator to the door. Then you remove the three bolts for the window motor which is toward the front of the door. You have to also disconnect the plug for the windo motor to remove the entire window regulator and motr that are all one unit. Replace the unit in the reverse way.