Want this question answered?
Remove the wheel from your 1993 Mercury Cougar. Loosen and remove the wheel bearing nuts. Remove the wheel seal and the wheel bearing. Reverse the process to install your new wheel bearing.
Remove wheel, remove the brake caliper and brake pads, Pull the dust cap. remove cotter pin. remove nut and washer. tilt the rotor back and forth to pop the bearings (front) remove rotor and pop the back bearings. This would be for a 2 wheel drive S-10.
Try www.midcomustang.com
Front wheel bearings on a 4 wheel drive Explorer are not serviceable, replace them.
2 wheel drive or 4 wheel drive? It makes a difference.
what tools do i need to remove the wheel cylinder on a 1993 pontiac bonneville
Begin by removing the tire and wheel from your 1993 Nissan. Remove the end of the axle. Remove the wheel bearing nut. Remove the wheel seal and the wheel bearing. Reverse the process to install your new rear wheel bearing.
It has 1 big hub bearing per side and you can not service them. It has factory sealed bearings. If there bad then you must replace the bearing.
wheel bearings?
take off center cover, remove large nut then use wheel puller to remove steering wheel
Remove the wheel Remove the grease cap with a screwdriver and hammer Unbend and remove cotter pin and bolt cover Remove bolt behind cotter pin Pull on rotor and hold onto outer bearings at the same time Rear bearings and seal can be removed by placing rotoe face up, and sticking a screwdriver through and tapping the inner bearings and seal out Remove 6 bolts that tire mounts to and reassemble on new rotor
u first shabbily ding dong yes that is u change it