0
after emoving wheel and brake drum you will have to teke brakes off. i usually do one side at a time so i can see how to put the springs back on. once brakes off indo brake line and tthen the two bolts that attach it to backing plate. after replacing you will have to bleed brakes
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Is the Chevy Corsica front wheel drive?
yes
How Rear Wheel cylinder 2000 Chevy Malibu?
remove rear wheel, remove brakes and cylinder is held on by 2 bolts from back of plate. remove bolts and brake line from cylinder !! somtimes you can take top nails holding brakes out to allow room to remove cylinder.
How do you change wheel cylinder on 2000 Chevy Malibu?
To change wheel cylinder on a 2000 Chevy Malibu, jack up the vehicle and remove the tires, brake drums and brake shoes. Spray the hydraulic line and fitting with CRC 5-56 and loosen hydraulic fitting. Remove the two mounting bolts and remove the wheel cylinder. Replace with new.
How do you replace a ignition key lock cylinder on a 90 Chevy pickup with tilt wheel?
Remove the steering wheel, Then remove the turn signals section. This takes some special tools.
How do you replace the wheel cylinders on a Chevy Lumina?
remove the rear brakes, then remove the brake line to cylinder. remove the bolt holding cylinder on. then pull out wheel cylinder. to install cylinder, position it in place, put bolt back in cylinder to hold it. hook back up the brake line then put the brake shoes back on. when done bleed the system if need be.
Is a Chevy Corsica a rear steer car?
NO. It is a front wheel drive, (FWD) with front wheel steering only.
What is a spindle on a 1995 Chevy corsica?
The spindle is what the front wheel is mounted on. It is the shaft that the wheel bearing slides up on.
How do you remove rear wheel bearings on a Chevy Cavalier?
Remove the tire and wheel from your Chevy Cavalier. Remove the end of the axle. Remove the wheel bearing nut. Remove the wheel bearing seal and the wheel bearing.
How do you replace the turn signal switch located on a 1992 Chevy Corsica?
Since the 92 Chevy Corsica is equipped with SRS (Saftey Restraint System), ie: Airbags, which is located in the steering wheel. In order to replace the turn signal switch you must remove the steering wheel. Therefore I would only highly advise you to take it to a dealer to have this done.
How do you install a wheel cylinder on a 1998 dodge grand caravan?
Rear wheel? Remove wheel Remove brake drum Loosen and remove brake line to wheel cylinder Remove mounting bolts at rear of wheel cylinder Pry brake shoes back from wheel cylinder Pull wheel cylinder off backing plate Install in reverse procedure Bleed affected brake line
Does a 1996 Chevy Corsica have rear wheel drive?
no all front wheel drive the best of my knowledge no all front wheel drive
How do you remove steering wheel Chevy lumina 2000?
How to remove steering wheel on Chevy lumina 2000
