answersLogoWhite

0


Best Answer

It takes a special tool available at parts stores. they should show you how to use it.

If you have a 13 mm flat cone wrench (for you old cyclists) like me, it slips right in and the clamp comes right out! Glad I still have the ols school tools.

If you need to make a tool, space the slot 13mm.

User Avatar

Wiki User

โˆ™ 2011-02-19 22:49:54
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides
๐Ÿ““
See all Study Guides
โœ๏ธ
Create a Study Guide

Add your answer:

Earn +20 pts
Q: How do you remove the window crank on a 2003 Saturn Ion 1?
Write your answer...
Submit
Related questions

How do you remove broken antenna on a 2003 Saturn ion?

how to remove and replace broken antenna on a 2003 Saturn ion


How do you remove the window crank of a 2003 Dodge Dakota?

door handle removal tool any auto part store in HELP section


Car stereo installation for 2003 Saturn vue?

remove 2003 Saturn vue radio


Where is the resevior for rear window washer fluid in 2003 Saturn vue?

The 2003 Saturn rear window washer fluid reservoir is located in the cargo compartment. The reservoir will be behind the drivers side panel, near the back door.


How do you remove the window crank handle on a 2003 ford cargo van?

Should have and Allen wrench slot in center --if not has horseshoe clip behind--tool available at auto parts store


How do to remove the window crank handle to get inside the door of a 2003 Chevy S 10 pickup?

there is a C shaped clip behind the handle. I have the tool to remove it you can get them at auto zone. you can also use a small pick to pull clip out but watch out it will fling out


How do you remove a door panel from a 2003 Trailblazer?

With a special tool, remove the door handle and window crank. Take out any screws you can find. With another special tool, remove all of the retainers oon the sides and bottom and raise it up to remove it.The special tools are available from the parts stores cheap.


How do you remove the window crank on a 2003 Chevy cavalier in order to remove the door panel to fix a rear passenger door that does not open?

You need a door handle removal tool. Go to any auto parts store and buy one. They're about $5


How do you remove the window crank handle from a 2003 Pontiac Sunfire?

It requires a special tool available at the parts store cheap. Use 2 Screwdrivers, force a rag between the door and the window crank handle to give you some space, then pry the clip apart or take a small hook, hook under the loop of the pin and pull up.


2003 Dodge Caravan power window motor replacement?

how to replace power window motor for 2003 dodge grand caravan? how to remove side panel dodge caravan 2003?


Where do you find crank sensor on 2003 Saturn vue 6 cylinder?

The V6 in the Saturn VUE is sideways (FWD) vs. the version used in the Cadillac Catera (RWD). On the Saturn, the crank sensor is mounted on the front side of the engine, sort of near where the trans mounts to the engine. Pretty easy to change.


Where is the crank sensor on 2003 grand am?

where is crank senser located on 2003 pontiac


Where is the crank sensor on a 2003 Z66 with 5.3 engine?

It is behind the starter. You will have to remove the starter to even see it.


How do you change crank case vent valve on BMW 325i 2003?

Remove the throttlebody to get access to the 2 torq, screws.


Location of crankshaft position sensor 2003 Saturn L200?

The 2003 Saturn L200 has a camshaft position sensor. It is located on the bottom front of engine behind the Starter. You will need to remove the two bolts that are holding the Starter to get to the sensor.


How do you charge a dead battery on a 2003 Saturn?

Remove battery cover and connect charger to side post battery.


2003 Saturn ion clunking when breaking?

2003 Saturn Ion clunking when breaking


How do you remove the window crank on a 2003 Ford Ranger?

2000 Ford Ranger Answer There is a thin plastic cover over the window crank handle. It pops out at the large end of the crank (the bottom) and will rotate out of the way so that you can get at the torx screw. The torx screw holds the handle to the shaft. It goes through the center of the shaft. You can use a flat screwdriver to gently pry the cover away from the large end of the crank handle. No special tool is needed. Once you have the handle off remove two other screws, one at the bottom of the door panel and one in the door arm rest. Then grasp the panel at the bottom and slide up to remove. There are no snap pins holding the panel in place. It slides up and off of the door latch for removal.


How do you remove a driver side door panel on a 2003 Ford Ranger XLT?

First remove the "cover" on the window crank handle. Pop it off, (it is a press fit and has hooks to hold the cover onto the rim of the center of the crank opposite of the crank arm) swivel it aside to get at the star drive headed screw that holds the handle onto the window crank shaft. After the handle's off remove 2 screws; 1 in the arm rest grab handle and 1 at the bottom farthest from the hinge. After the screws are out the plastic panel needs to be pushed up (there are plastic hooks that engage holes in the inner metal panel) this is tricky but be patient and DON'T use screw drivers or other prying instruments or you'll ruin the plastic panel and it will never fit tight again. Good luck!


Which robot or satellite discovered Saturn in 2003?

Saturn was not discoved in 2003. Saturn has been known since ancient times. However, the Cassini and Huygens probe reached Saturn in 2004.


How do you check 2003 Saturn Vue transmission fluid?

How do you check the transmission fluid on a 2003 Saturn vue


When was Saturn Ion created?

Saturn Ion was created in 2003.


Will 2003 yz250f crank fit a 2002 yz250f?

NO!! they made changes to upgrade the crank from 2002 to 2003 so if you had to do this, itd cost you money in conversion parts and youd be getting a weaker crank


How do you replace a fuel filter on a 2003 Saturn Ion?

locate fuel pump wiring in 2003 Saturn L200


Where is the crank senscor on 2003 silverado?

If it is a V8 then it will be behind the starter, You will have to remove the starter to even see it. The V6 engines have it in the passenger side of the timing cover.