0
Remove the plastic covers off the wiper arm retaining nuts.
Remove the wiper arm nuts with a 13mm socket.
Twist and pull with your finger tips and finger nails at the base of the small rubber squirt tubing off the hard plastic squirt delivery tubes.
You may have to yard up and down on the wiper arms pretty hard to get them loose from their tapered shafts. Don't be a mindless gorilla but be brave and keep at it. They will come loose.
What else can I help you with?
What is the windshield wiper size for a 1998 Pontiac Sunfire?
22 and 17
What is the windshield wiper size for a 2001 Pontiac sunfire?
18'' and 22'' pretty sure.
How do you remove the windshield wiper blades from a Pontiac sunfire '99?
i know how to put one on. lift the blade and arm as high as it will go. then tilt the wiper towards you. it slips on and cicks into place. try doing that in reverse.
How do you remove driver's side windshield wiper arm from '97 Pontiac grand am?
Find the largest hammer you can, strike the wiper repeatedly, remove, duct tape new wiper on.
Where is wiper motor on 97 Pontiac Grand Prix?
The wiper motor on a 1997 Pontiac Grand Prix is located on the driver's side, beneath the windshield wiper assembly. To access it, you typically need to remove the windshield wiper arms and the plastic cowl cover that sits at the base of the windshield. The motor is mounted to the firewall and connected to the wiper linkage. If you're servicing it, ensure the battery is disconnected for safety.
How do you change windshield wiper motor on 1994 dodge ram?
Remove the windshield wiper arm from the windshield wiper motor. Remove the wiring harness. Remove the retaining nut. Reverse the process to install the new windshield wiper motor.
How do you remove the windshield wiper motor on a 1988 Pontiac Firebird?
To remove the windshield wiper motor from a 1988 Pontiac Firebird, first disconnect the negative battery cable to ensure safety. Then, remove the wiper arms by taking off the nuts securing them and carefully prying them off the motor spline. Next, access the motor by removing the interior panel under the windshield, and disconnect the electrical connector. Finally, unbolt the wiper motor from its mounting bracket and carefully pull it out.
Where is the windshield wiper control module located on a 1993 Pontiac Transport?
The 1993 Pontiac Transport windshield wiper control module is located on the firewall in the engine compartment. The windshield wiper control module will be on the passenger side of the firewall.
How do you remove a windshield wiper motor on a 2000 Pontiac Bonneville?
To remove the windshield wiper motor on a 2000 Pontiac Bonneville, first disconnect the negative battery cable to ensure safety. Then, remove the wiper arms by taking off the retaining nuts and gently pulling them off the splines. Next, remove the cover panel at the base of the windshield to access the motor, disconnect the electrical connector, and unbolt the motor from its mounting bracket. Finally, lift out the motor and replace it if necessary.
Where is the Windshield Wiper Motor located on the 1994 Pontiac Grand Prix SE?
The windshield wiper motor is located just below the windshield wiper blades and is covered by a black panel.
What is the windshield wiper size for a 2000 Pontiac Sunfire gt?
The 2000 Pontiac Sunfire wiper blade sizes are 22" drivers and 17" passenger side wiper blades. Do not buy by length-only however. See the Sources and Related Links section below for more information. Since there are over 22 different wiper arm attachments - be sure to lookup exact wiper blade part numbers by vehicle make, model and year for the brand wiper you decide to purchase. This ensures correct length AND correct attachment.
Where is relay switch located for wipers in 2000 sunfire?
Under the cowl at the base of the windshield, on top of the wiper motor, three T20 Torx screws to remove.
