To remove the windshield wiper motor on a 2000 Pontiac Bonneville, first disconnect the negative battery cable to ensure safety. Then, remove the wiper arms by taking off the retaining nuts and gently pulling them off the splines. Next, remove the cover panel at the base of the windshield to access the motor, disconnect the electrical connector, and unbolt the motor from its mounting bracket. Finally, lift out the motor and replace it if necessary.
underneath the dashboard on the passenger side.
To accessthe blower motor, open the hood. Look on the plastic fascia under the windshield wipers in front of the passenger. You'll see an opening plate with two little tabs. Lift those and remove the plate.
The blower motor on a 1997 Pontiac Bonneville is located next the evaporator core. It will be mounted behind the glovebox on the passenger side of the vehicle. Remove the glovebox, mounting hardware, and sensor clips. The blower motor will be able to be replaced.
i need to know how to remove a blower motor from a 2002 bonneville.
To replace the blower motor on a 2004 Pontiac Bonneville, first disconnect the negative battery cable to ensure safety. Remove the passenger side lower dash panel and locate the blower motor housing. Unscrew the motor from its housing, disconnect the electrical connector, and then replace it with the new blower motor. Reassemble by reversing the steps and reconnect the battery.
Remove the windshield wiper arm from the windshield wiper motor. Remove the wiring harness. Remove the retaining nut. Reverse the process to install the new windshield wiper motor.
250 HP
Under passenger side by firewall.
yes
The motor is under the plastic grill that is at the bottom of the windshield. It's held in place by a bunch of plastic "rivits" that you have to remove to get the grill out.
Rear of engine follow exhaust manifold at rear of motor(closest to firewall) you will see oxygen sensor there.Simple to remove(1 only on this motor)
You have to remove the motor mount. Once the motor mount is removed you can remove the old water pump and install the new one. Make sure the area is clean before you install the new one.