take off the wheel. unbolt the 2 lower strunt bolts, to swing the brake assembly out, pull that end of the axel out, then give the axel a good pull out and it should pop out of the transmission.
The starter on a 1991 Toyota Tercel is located in the front of the engine. It will be located on the left side.
The timing marks on a 1991 Toyota Tercel are on the crank pulley. They are located on the front of the pulley and under the cam.
Yes, drums on the rear, discs on the front.
There is a little wedge at the bottom, stick a nail fail there and pop it out. Then you just have to pull the cover down to reveal the speakers
You have to remove the hole corner lamp so you can get to the bulb in the back, you just need a srew driver
The recommended tire pressure for the front and rear tires on a 1996 Tercel are 32 psi. In metric units it is 221 KPa.
The coolant temperature sensor can be found on the front of the engine, near the thermostat. Remove the coolant temperature sensor retaining nut, to replace it.
how to remove front bumper on Toyota avensis 2003
Remove your front axles.
Weld center diff and remove front ring gear. Remove front axles. has been done.
front are 6.5" and the back are 4x6"
It can be done with the engine still in the car. You'll have to remove the transaxlehousing and clutch. To get at all the bolts for the trans axle housing you need to remove the battery, the air filter assembly, the plastic splash guards under the car, the starter, clutch cylinder on the front of the housing, the speedometer cable, shift mechanisms (mark the front and rear ones carefully..very important), remove the wheels, separate the front wheel assemblies from the front control arms on both sides, drain oil from trans axle housing, tap out trans axles, remove clutch cover and then you'll see the flywheel. It'll take you about six or seven hours to complete the job from dismantling to re-assembly.