Want this question answered?
how to remove the paneling around the heated seat controls how to remove the paneling around the heated seat controls how to remove the paneling around the heated seat controls
remove the stereo remove the hazard switch and the rear defroster switch their is one Phillips screw under each switch remove the climate cable underneath on the heater box remove the center cluster completely buy pulling or prying out the bottom clips unscrew the climate controls from the center cluster
how do I remove the climate control from a 1999 toyota 4runner
According to my Haynes manual all you have to do to get at the stereo is remove the center bezel. that is the plastic panel covering the area around the stereo and the climate controls. just grip the plastic between the radio and the climate control panel and pull. make sure to unplug the electrical connector for the courtesy light before you fully remove the bezel.
Remove the cover around the controls and you will see the bulbs inside the climate control unit. It just pulls off.
There are no shortcuts for this repair. You have to remove the entire dash. Its located on the pasenger side behind the dash just above the radio and climate controls.
1997-2001. Grasp the lower corners of the trim panel in the center of the dash that goes around the stereo and the climate controls. Gently pull out, and slightly up. Unscrew the switch panel. Disconnect the wires from the switches. Remove the switches.
please send me instructions on how to remove alternator on Chrysler 2001 lhs?
You need to remove the two screws above the climate controls. Then you pull the bezel around the radio off the dashboard. Next, you unscrew the four screws holding the deck to the dashboard and pull out the stereo and twist it so you can see the backside. Finally, you unplug and pull out all of the wiring.
How do i remove the anti theft system on my 1995 Chrysler Cirrus?
well its complicated you have to remove the glove box and disconnect the cable that controls the hot/cold setting on the controls then you have to remove all the scres holdin face plate on some are underneath so you have to take out the ash tray to get to them make shure you take off all the knobs for climate control and the radio then disconnect everything you need to so you can work on the faceplate
You have to remove the exhaust manifold to get to the starter.