In old lawn mowers ,the rear wheel can be very hard to remove. Best thing to do is cut the tire off the rim. Leave a 2 inch rubber on the sides . Drill a small hole in this 2 inch sidewall and put a large screw driver and twist it sideways. This will separate the rubber from the rim and now you can pull it off the rim.
Take your new tire and lube the inside flange with dishwasher soap and slide it on the rims. Very easy. I have done this a dozen of times. This will save hours of beating and pulling with a bar puller or a slide hammer.
The only time i use a slide hammer or a bar puller ,is when i have absolutely no choice but to remove the rims. In this case ,take it to a shop and let them remove it with an impact wrench. Sometimes you can destroy or badly damage your rims by doing it yourself. I have done that too. Hope this helps.
42" Cut Riding Mowers call for around 12 to 14 psi.
Put the lawnmower on blocks so that the tire is not touching the ground. Loosen the wheel lugs. Pull the tire off. Replace with a new tire.
Filling a tire for a lawnmower is easy. All you have to do is by a new tire.
Yes, just be sure rim is same size as the ones tire is being mounted to.
If you are removing a rear wheel from a riding mower with a square keyway, there is no need to remove the keyway. The tire and rim will slide off with it in place. The rim is slotted all the way through. After removing the wheel you can simply grab it with pliers if you need to remove it for some reason.
Two most common reasons are (1) low tire(s) and (2) mower deck not level. Low tire being the main and most common.
Dynamite
Take the black plastic cap off the middle of the rim by prying it off with a screwdriver. Make sure the mower is in reverse or drive.... not park. Under the black plastic cap is a regular bolt. Unscrew it counter-clockwise. That's it.
15x8 tire = 14.4 oz.
my manual says 32psi. but it depends on the terrain. if your tires slip or your tractor jolts to much when riding, you ride will feel a lot better with less air.
yes
It is not threaded.