Take off the camshaft.
Schrader valve on fuel rail.
5,340 lbs according to uhaul.com
You can remove network lock from Samsung E250 using code that can be purchased from any vendors online like ProUnlocking.com
Overdrive allowed is the normal position
yes
under the passenger door bolted to the frame rail
Remove the inner door panel and unhook the wiring at their respective plug ins, remove the plastic covering and locate all the linkage bars associated with the handle. Next remove the nuts or bolts securing the handle. Gently wiggle the handle free from the outside. Installation is the reverse of this procedure.
well in my experience i like to send it to the mechanics and let them bloow it up
Use a strap wrench around the base.
Your climate control in your 1998 Ford E250 Cargo Van blows cold air when in heat position and sometimes it blows warm air when in the cold position?
4.2L, 4.6L, 5.4L and 6.8L Engines 1. Disconnect the negative battery cable. 2. Remove the vacuum hose from the EGR valve. 3. On the 4.6L engine, remove the nut and brake booster bracket. 4. On the 5.4L engine, remove the DPFE sensor retaining nuts and place the sensor to the side to allow access to the EGR tube. 5. Disconnect the EGR valve-to-exhaust manifold tube from the EGR valve. 6. Remove the EGR valve mounting bolts, then separate the valve from the intake manifold. 7. Remove and discard the old EGR valve gasket, and clean the gasket mating surfaces on the valve and the intake manifold. To Install: 8. Install the EGR valve, along with a new gasket, on the manifold, then install and tighten the mounting bolts. 9. Connect the EGR valve-to-exhaust manifold tube to the valve, then tighten the tube nut to 25-35 lbs. (34-47 Nm). 10. Connect the vacuum hose to the EGR valve. 11. On the 5.7L engine, install the DPFE sensor. 12. On the 4.6L engine install the brake booster bracket and the retaining nut. 13. Connect the negative battery cable.
If there is no drain plug you will have to remove the pan to drain the fluid. This removes 4-5 quarts out of 12 or so in the transmission. You can also take it to a shop and have them do a fluid exchange where they pump out all the old fluid and replace it with new.