put a fuel line cleaner in it like start your engines...or put WD-40 in it
Water.
To remove Thompson's Water Seal from brick, you can use a pressure washer with a high-pressure nozzle or a chemical stripper specifically designed for masonry surfaces. Follow the instructions on the stripper and wear protective gear to ensure safety. It may take some effort and multiple applications to fully remove the sealant.
No, it most cases it it the GPM demand
Yes, bleach can be used in a pressure washer. Place the 12 percent bleach in the solvent hose in order to dispense the bleach with the water.
Basically, a pressure washer uses pressurization to deliver a concentrated spray of water or liquid. The force of this stream enables you to deep clean surfaces. But be careful what you use a pressure cleaner on - the force of the water can harm some surfaces. A pressure washer is a machine that pressurizes enough pressure to blast out a forceful spray of water that can deep clean an area and rid it of grime and mold. Pressure washers are used by painters to peel away paint from a house.
pressure washer ***follow the intructions on your pressure washer so you wont damage you patio, use the correct nozzle***
Take a clean rag and stuff it into the tank - it will soak up the water.
As the water heats up the washer in the tap, it expands. This causes the washer to partially block the open valve.
You can try to fish what ever is blocking the passage with a bendable tool or you can shut off the water valve and take the toilet outside and flush it with a high pressure hose something like a pressure washer.
If it has no pressure your problem should be on the pump. The three things I'd recommend you to check are: Packings, Unloader and Valve Kit.
Dirt and grime from brick and concrete can be cleaned up quickly with just water and the correct pressure washing technique. All you need is a pressure washer, good water supply and a pressure washer surface cleaner from bestcargurus. A pressure washer surface attachment gets cleaning jobs done up to 4X faster than the usual spray nozzles. The splash-free skirt keeps you dry while you clean and you won’t experience any streaking problems due to its ability to keep nozzles at a fixed height from the surface.
If you run hot water through the pump of a pressure washer, it will ruin the seals in the pump. The hot water causes their seals to swell, and the pistons will then rip them apart. Some machine are able to run hot water, but the have special seals inside. Ben - Great Lakes Cleaning Systems www.GreatLakesCleaningSystems.com