Take the steering hub and knuckle to a machine shop. The bearing must be pressed out and a new one pressed into the hub.
how do you change wheel bearing on 98 mercury mountaineer
how do you replace a wheel bearing on an 1985 oldsmobile regency 98
how do you replace a wheel bearing on an 1985 oldsmobile regency 98
With the 98 Durango safely lifted, remove the front wheel. Remove the locking hub. The hub removal is different depending on the hub type. Remove the brake caliper. Remove the axle nut, and slide off the bearing housing. The inner and outer bearings and races should be replaced.
how do i replace a wheel seal
107 ft/lbs.
No. The '98 Jeep Wrangler has a sealed bearing hub assembly.
After you remove the wheel, remove the caliper and caliper mounting bracket. There is a nut on the end of the axle shaft. Remove the nut. There are three bolts on the back of the steering knuckle that hold on the wheel bearing. Remove these bolts. Then with a punch or chisel and hammer, strike the axle shaft until the old bearing comes out. Reverse procedure to install. Don nut re-use the axle shaft nut. Do not under- or over-tighten the axle shaft nut. Torque for the nut is 180 ft lbs.
wheel studs? head studs?
== == they are however crush bearings and need a special tool to set torque to 155lbs. 89-98 covered here. http://www.kick-fix.com/hubs/hubs.html the tool is $80 == == 1993 and later use a sealed cartridge wheel bearing which is not repacked, only replaced as a unit...A locknut sets the bearing preload at 180 ft/lbs.. To replace, slip mark and remove hubs, remove lockplate, locknut, trust washer, and seal. Remove Hub and Wheel bearing snap ring and then bearing will probably need to be pressed out of the hub.. It is involved...(Get a good manual or a good mech)
on the alumman block that is next to the brake master or its part of the wheel bearing
That's never going to happen as the 98 Monte is front drive.