== == they are however crush bearings and need a special tool to set torque to 155lbs.
89-98 covered here.
http://www.kick-fix.com/hubs/hubs.html
the tool is $80
== == 1993 and later use a sealed cartridge wheel bearing which is not repacked, only replaced as a unit...A locknut sets the bearing preload at 180 ft/lbs.. To replace, slip mark and remove hubs, remove lockplate, locknut, trust washer, and seal. Remove Hub and Wheel bearing snap ring and then bearing will probably need to be pressed out of the hub.. It is involved...(Get a good manual or a good mech)
There are two taper roller bearings in each front hub, on a Samurai.
You will need to remove the tire and wheel from your 1997 Suzuki. Remove the axle end. Remove the wheel bearing nut. Remove the wheel bearing and the wheel seal. Reverse the process to install the new wheel bearing.
No, bad front wheel bearings would not prevent a transmission from shifting. If your car has bad front wheel bearings you will notice wheel noise or wheel looseness.
the truck has hubs. 4x4 front wheel bearings are not serviceable.
The 2008 Suzuki SX4 has front wheel drive.
The 2011 Suzuki Kizashi has front wheel drive.
The 2013 Suzuki SX4 has front wheel drive.
The 2010 Suzuki Kizashi has front wheel drive.
The 2012 Suzuki Kizashi has front wheel drive.
The 2012 Suzuki SX4 has front wheel drive.
The 2009 Suzuki SX4 has front wheel drive.
The 2010 Suzuki SX4 has front wheel drive.