With a hammer and pry bar.
Make your life easy and just break off the door handle. When you are finished with your project, just replace the door handle with a new one from the dealer.
break the window :)
Push the door panel in around the window handle and use a screwdriver or a piece of wire with a hook to pull the clip off....it's in behind the handle.
no, different designs.
its has like a safety pin in the handle where u roll down the window you have to pop off with a flat head screwier driver
how do you remove a car handle window for a 1995 lincoln car?
Remove inside door handle and window crank handle, remove inside door panel, remove vent window and channel assembly, remove window.
Identify the fault/problem. Repair or replace
To replace the window crank handle on the 1993 Geo Prism, first remove the interior door panel. Then, access the screw that holds the window crank in place and remove it. You can then remove the handle itself.
magic
I'm presuming you mean the actual handle you grab. If that's the case, the handle slides over the crank shaft and a "C" shaped spring (actually, it looks just like the Ohm symbol Ω or capital greek letter omega) locks into a notch in the shaft through holes in the handle. What you need to do is remove this spring and then the handle will just pull right off. Something I've found to work is sliding a towel between the handle and the door. It will catch on the points of the spring "Ω" and pull it right off!
This page will tell you how to do this......good luck. http://www.maintainyourcar.co.uk/1999_hyundai_accent_window_winde.htm