no, different designs.
Its should be same thing
how to replace window washer pump on 2008 hyundai elantra
break the window :)
magic
Found my own answer: No; While they do share the same first five digits of the part number (these are the only numbers you'll see on model specific diagrams) the second 5 digits of the part number (which are NOT shown on model specific diagrams), are specific for each model, and are not the same between the two.
With a hammer and pry bar.
Identify the fault/problem. Repair or replace
I am referring to stop light located at back window.
If it's anything like the 1995 Accent, and assuming you'll need to get the old one out, you'll need to remove the door trim panel and water shields, and lower the window glass. Then you'll scribe or paint (or otherwise mark) the two window channel-to-regulator bolts and remove them. Remove the glass by tilting the glass forward while lifting it up (and out) of the opening. Remove the regulator retaining bolts and then slide the regulator (up) out of the opening in the door (where you just took the glass). Slide new regulator in where you just removed old one and secure with retaining bolts. Reverse your steps in putting glass in, make sure it goes into the glass channel studs, making sure the rear edge of the glass is the same distance from the rear channel bolt hole as before (you removed the glass). Replace weather stipping and trim.
This page will tell you how to do this......good luck. http://www.maintainyourcar.co.uk/1999_hyundai_accent_window_winde.htm
Access the pump motor through the front passenger wheel panel
what is a window regulator on a 01 vw jetta