0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is the fuse for the 1998 Chevy Prizm window control?
The 1998 Chevy window control fuse will be the number four fuse. The number four fuse will be in the first column, fourth from the top.
How do you remove the rear seat on a 2002 Chevy Prizm?
I've got a better question, why is this question in the Chevy venture forum ?
How do you change the starter on a 1999 Chevy Prizm?
Remove the positive cable from your 1999 Chevy battery. Remove the cables from the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.
How do you remove the door lock rod clip retaining on a 1999 Chevy Prizm?
remove screw on inside door handle ,pull door handle; with rod still attached; out slightly from door. you will see on end of roda white nylon clip where it attaches to the handle. unsnap the clip from rod by pivoting the clip to the side of the rod. itsnaps on and off of the rod. then lift rod end up and out of the clip still in the door handle.
Is Chevy Prizm also a Nissan?
no, prizm is a re bage of Toyota collora
Is there a fuse for window switch on a 2001 Chevy Prizm?
Your are LSI model right? No there is not. window doesn't roll down or up. You might have bad window motor or switches. Check your door jamb wire connection that runs to the window motor. Good luck
How do you replace the cigarette lighter in a 1998 Chevy Prizm?
Remove the retaining ring at the top of your 1998 Chevy cigarette lighter. Slide the cigarette lighter out and remove the wiring harness. Reverse the process to install the new cigarette lighter.
Who is the maker for the motor of a Chevy prizm?
Toyota
How can you put a v8 into your Chevy prizm?
Drop it in
Diagram of serpentine belt 2000 Chevy Prizm?
replacing serpentine belt on 2000 chevy prizm need help
Where is the throttle body located on a 2001 Chevy Prizm?
I have a 99 Chevy prizm. The throttle body is located on the driver side of the car in the engine. Following the air filter housing (the black tube) you will it connected to the engine. It will have a clamp on it. You need a screwdriver to loosen the clamp. It might be a bit hard to remove.
How do you remove the front door panels to get to the front speakers on a 2000 Chevy Prizm?
http://prodactor.blogspot.com/2005/09/removing-door-panel-from-toyota.html
