How do I replace the washer on my 200 Continental?
Don
as for as what, the motor, the wipers, the fluid container, what?
the sensor is located on the passenger side under the hood, look in between the bumper and the radiator all the way to the left, on top of the washer fluid container. the container is mounted to the front of the fender, you need a small hand gppd luck.
Remove the plastic front and it will be visible just under the right side headlight. Lodged in the washer fluid container.
Most of the later GM washer pumps are located at the botoom of the washer fluid container. You will need to remove the tank to get access to the pump.
is it out or just clogged, if its out the pump should be attached to the washer bottle on the bottom, but check to see if its clogged first, take it apart.
It is on the driver side under the washer fluid container. You have to remove the cross support bar and the washer fliud conainer and the airfilter box. It takes about a half hour to remove and replace. All bolts are metric.
Pull out the container that you fill with washer fluid. Its on the bottom of that container.
the compressor is located under windshield washer tank and airfilter box both need to be removed. then unplug wire at compressor, there are three nuts 10mm holding the compressor in you get at them from under car.
There is only window washer solvent container - it feeds both front and rear.
You have to take the battery out and remove bolts at the top of the reservoir. Then you have to remove the plastic pins inside the front left wheel well to allow you access to the bottom of the reservoir. There are bolts on the bottom to remove as well. You have to remove the hoses from the washer pumps and the reservoir should slide out thru the wheel well.
Follow the hoses from the washer outlet spray heads backward to the washer reservoir.
You have to remove the black plastic rivets on the winshield washer fluid container that sits above the battery and remove it. you will then see that battery and be able to replace it.