0
Assuming that you mean "wiper blade" (blade and frame) which are replaced often rather than "wiper arm" (piece from the spindle at the hood to the wiper blade) which are rarely ever replaced, the 1982 Dodge Pickup has the most common hook-end wiper arms. See sources and related links below for installation videos. Also, purchase the replacement blades first and there will be additional instructions/illustrations on the replacement packages. Locate and press the tab or button where the wiper blade is inserted into the hook of the wiper arm and pull wiper blade out of hook. You may have to rotate and flex the blade to make enough clearance for the hook to pass through.
What else can I help you with?
How do you get the rear wheels not tires off your 1982 Dodge D50 pickup?
Remove the lug nuts by turning counterclockwise.
How do you remove wiper arm on dodge d 150?
i got a dodge 1982 truck. i wedged a screwdriver underneath the wiper, right at where it pivits. It's pressed over teeth. Try to rotate the screwdriver around a little. It should come off little at a time.
Where is a ballast resistor on a 1982 Dodge pickup?
On the firewall pass side.
What is the air gap setting on a pickup coil for an 1982 dodge ram van with a 360 engine?
1982 318 pick up coil gap
What bucket seats will fit in a 1982 Dodge D150 pickup?
i put seats out of a ramcharger in my 84 you can really put almost any seat in them
What size is axle nut on 1982 dodge rampage?
The axle nut for the 1982 Dodge Rampage is the size ofÊ2-9/16. You need to know the exact size in order to get a socket to remove the nut.Ê
Where is the fuel pump located on a 1982 Dodge Ram?
Where is the fuel pump located on a 1982 Dodge Ram?
Where is the spare tire located on 1982 Dodge caravan?
dodge went bankrupt in 1982. there is no spare tire in the caravan.
When did Marshall Dodge die?
Marshall Dodge died in 1982.
Where can you find a wiring diagram for a 1982 Chevy pickup?
autozone.com
How do you get the radio out of a 1982 Datsun pickup?
To remove the radio from a 1982 Datsun pickup, first disconnect the negative battery cable to avoid any electrical issues. Then, carefully remove the dashboard panel surrounding the radio, typically involving unscrewing a few screws or clips. Once the panel is off, you can unscrew the mounting screws holding the radio in place and gently pull it out. Finally, disconnect the wiring harness and antenna cable from the back of the radio.
Where is the slave cylinder on your 1982 Toyota pickup?
on the passenger side of the transmission
