To remove the wiper arm on a 1993 Dodge Dynasty, first, lift the wiper arm away from the windshield to access the base. Use a small socket or wrench to remove the nut securing the wiper arm to the pivot shaft. Once the nut is removed, gently wiggle the wiper arm back and forth while pulling it upwards to detach it from the shaft. Be cautious not to damage the windshield during this process.
To remove the rear wiper arm on a 2007 Dodge Nitro, first, lift the wiper arm away from the rear window. Locate the small plastic cover at the base of the wiper arm and carefully pry it off to expose the nut underneath. Use a socket wrench to remove the nut, then gently wiggle and pull the wiper arm off the splined shaft. If necessary, a puller tool can be used to help loosen the arm if it’s stuck.
At the base of the wiper arm is a small "pin" sticking out. Pull this pin outward to release the entire wiper arm. Reinstall by pushing the pin in.
Remove the windshield wiper arm from the windshield wiper motor. Remove the wiring harness. Remove the retaining nut. Reverse the process to install the new windshield wiper motor.
it just pulls up off of the splines on the motor stud, you can buy a wiper arm removal tool to make it easier to get off.
remove the caps at the end of the wiper arms. Unscrew the nut holding down the arm and it should come off.
Lift cap on the end of the windshield wiper arm where it connects to the wiper motor assembly. Under the cap you will see a nut. Remove the nut with a 15mm socket. Wiggle the wiper arm back and forth until it comes off.
At the base of the arm where it attaches to the wiper transmission, remove the little black cap (just pry it off ) and tighten the nut under there. A 15- or 16mm socket should do it.
Remove plastic cap. Remove nut. Pry up wiper arm.....
Remove the wiper arm retaining clip. The retaining clip will be just below the wiper arm connection. Hold the retaining clip in and the wiper arm will come off.
A wiper arm on a 2001 Honda Civic is screwed on. To remove it unscrew the mounting hardware and take off the wiper arm.
you just pick up the wiper arm