Remove the ligth assy and unscrew it from the rear.
It is actually a wiper control module that controls this. I have replaced many of them. It is the cover that is screwed to the wiper gear box. Remove both wiper arms. Remove the plastic cowl cover below the windshield that covers from side to side. Once inside you will see the wiper motor/transmission assy. Disconnect the electrical connector, and remove screws from cover, and replace it.
sometimes you can buy the compleate unit from a salvage yard, but iff you want to play you will need some torx sockets. remove the wiper motor assy. and fix it on a bench.
If you are talking about the tail light the lens is not a separate part of the lamp assy. Replace the complete assy by removing the two screws on the outside and unpluging the lamp socket.
remove wheel remove brakes/caliper/caliper bracket/rotor remove cotter pin/axle nut remove 4 bolts from wheel bearing assy unplug electrical connector for ABS, if has it tap axle end lightly to dislodge fron wheel bearing assy may need pry bar and hammer or air chisel to remove wheel bearing assy from vehicle clean orifice well and installation is the opposite
EJ says pull out the wiper assy away from windshield. Locate the clais in the middle of the wiper. Press clip relase tab and push the blade assy down. It should slide out easily.
You need to remove the bumper assy in order to access the Head lamp, also be sure to by all fender covers clips before you do that.
remove the side marker light assy Phillips screws, the assy will slide out. you then have access to the three 10mm bolts holding the fog light assy in. remove then and push out the fog light assy. then remove the four Phillips screws from the corners of the fog light to separate the assy. then change the bulb and put back together
Underneath the wiper motor assy.
Really not that bad to do. Order of removal remove wheel remove brake/ brake assy/caliper remove wheel bearing OR remove ball joint/tie rod and move spindle out of way to be able to pull axle out pull u-joint and axle out replace u joints assy is reverse of removal
the sensor is part of the fuel pump assy and comes out through a hole underneath the matting in the trunk.... remove the cover and remove lines from assy and then remove assy from tank.....make sure to relieve pressure from fuel lines before you remove lines due to residual pressure in the lines...
you have to either remove the intake manifold or be really really really thin. also removing the cowling where the wipers and motor assy are will help