Want this question answered?
If a Maytag washer fills with water but does not agitate it could a problem with the switch in the lid. There is a switch that locks the lid down during agitation and spinning. The magnet could be defective.
"Kenmore" is a brand name for Sears, not a manufacturer. Your washer was most likely made for Sears by Whirlpool. You can tell by the first 3 digits of the model number, ie: 110.9764882 would be a Whirlpool since "110" is their manufacturer's code. The lid switch is typically just under the top of the cabinet to the right of the opening where you put the clothes in. There will be a slot there that corresponds with a plunger on the lid itself which actuates the switch below. For more help see www3.sears.com for a complete breakdown of your model.
sears parts dept... www.sears.com in the parts section...or bring a model number to sears parts center and order.
These machines do not have belts. Lid switch is your most probable culprit. Though there are other parts that will stop it from spinning.
The address of the Kenmore Library is: 6531 Ne 181St Street, Kenmore, 98028 M
Vous vivez à Kenmore.
Make sure the unit is unplugged, then used two butter knives to insert in the front part of the lid...about 2 inches in from the outside corners to raise the lid. ANS 2 - Don't risk making your wife mad by ruining the butter knives ! -try two small pry bars or even flat screwdrivers.
Kenmore
kenmore.
Kenmore
Kenmore
The address of the Kenmore Heritage Society is: Po Box 82027, Kenmore, WA 98028-0027