0
IA Kenmore washer model number 11024822200 will not spin Could this be a belt and how do you fix it?
Wiki User
∙ 12y ago
These machines do not have belts. Lid switch is your most probable culprit. Though there are other parts that will stop it from spinning.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Why does your Kenmore 70 Series washer not stop filling with water?
There is a clear hose attached to the water level control of the washer. The other end of the hose is attached underneath the washer. The hose isn't attached with any hose clamps so if the washer rocks from a uneven load it could come disconnected and on the next load the water fills up and never stops. Just disconnect the water and electric and the drain and turn the washer on its side look for the hose and reattach it to the hookup underneath-- I just fixed mine, I thought I was going to be buying a new washer but this one still works great now! Hope this helps- Jesse
How many amps does a regular clothes washer use?
Could be about 13 amps at 240 v.
What does it mean when my washing machine smells burning?
Contact your appliance repairman. Unplug the appliance first, and check the area to see if the smell could be coming from somewhere else.
In what country are MayTag Washer manufactured?
Most washers by Maytag are produced in Ohio. Could also be made in the Oklahoma are. But ALL Maytag appliances are 100% manufactured in the USA.
What is the cost to install a washer and dryer in an apartment?
The place you buy if from may do it for free, if new, or charge a small fee of $50-100.oo or less. If you hire a handy man that could vary. Both appliances come with directions how to hook up. The washer is easier than the dryer. You have a hot and cold line that connects from the washer to the spickets behind the washer, they are marked on the hoses. There is another hose that goes in the back of the washer that goes to the same spot that drains the water out on the spin cycle and a plug. On the dryer there is a plug and the vent hose that goes from the back of the dryer to the vent hole in the floor or wall. Takes less than an hour to do both. This is IF you have hook-ups already in place for a washer and dryer. If not, the costs are going to be a lot more significant. The cost depends on where you are putting the washer and dryer. If plumbing and electrical lines are close by it might run you about $400-500 for everything. (water lines to the washer, drain for the washer, electrical to the dryer and vent for dryer) However, it can be several hundred dollars more if you need to run plumbing and electrical lines significant distances (20 ft or more). To make it the cheapest possible, pick a location where water lines and an electrical box are less than 10 ft away. Also, if you do it yourself, you can save a lot of money and might only spend $100-200 in materials.
Kenmore washing machine will fill with water and drain off but will not spin water out or wash?
If a Maytag washer fills with water but does not agitate it could a problem with the switch in the lid. There is a switch that locks the lid down during agitation and spinning. The magnet could be defective.
Where could one go to order replacement Kenmore vacuum parts?
A good place to go to order replacement Kenmore vacuum parts is online as Sears Parts Direct. They have parts to 3,236 Kenmore Vacuums. You will need the part or model number to get information on the part.
Where could one buy a Venta air washer?
A Venta air washer could be purchased from a number of online retailers. Some examples would be eBay, Amazon, Wayfair, Bed Bath & Beyond, Living Direct and Sears.
What is the part underneath the windshield washer reservoir?
It could be the windscreen washer motor
Why does your Kenmore 70 Series washer not stop filling with water?
There is a clear hose attached to the water level control of the washer. The other end of the hose is attached underneath the washer. The hose isn't attached with any hose clamps so if the washer rocks from a uneven load it could come disconnected and on the next load the water fills up and never stops. Just disconnect the water and electric and the drain and turn the washer on its side look for the hose and reattach it to the hookup underneath-- I just fixed mine, I thought I was going to be buying a new washer but this one still works great now! Hope this helps- Jesse
Where could one find reviews of different Kenmore humidifiers?
Reviews for Kenmore humidifiers can be found online at a variety of sites. Reviews can be found on the Kenmore website or a site called consumer reports.
Kenmore washer just fills with water it does not advance TO cycle?
It could be a problem with the belt. Call Sears and have someone come out to diagnose; it may cost you some money to do that, but at least then you'll know if you need a new machine (or if repairing this one makes sense).
Where can one purchase certified Kenmore appliance parts?
Kenmore appliance parts can be found at the website sears parts direct, the website has about 200 parts for every model of appliance made by Kenmore you could possibly want.
How much could you get for a washer motor?
956451561561566$
Where is the windshield washer pump on 1995 Taurus?
It could on the bottom if the washer fluid reservoir - look there first.
What makes your clothes smell sour when they come out of the washer?
It could be any number of things. But it is most likely due to the clothes having been left in the washer for longer than they should have been and they mildewed, or it could be that the water used has some kind of bacteria in it that makes the water itself sour.
Is there a small portable washer I could take on vaccation with me for my clothes?
There is the Haier HERHLP21E Portable Washer with Stainless Steel Tub.
