0
It could be the windscreen washer motor
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Where is the charcoal canister in dodge stratus 1999?
its behind the front right side fender(nearly touching the bumper cover inside) in behind the windshield washer reservoir. you need to first take the windshield washer reservoir off and there it will be if the part im thinking of is your part source: i fixed mine and have to put it back in place
Is the sensor for windshield washer fluid part of a kit?
NO!
Where is the windshield washer pump fuse on a 1996 geo prism?
The pump is attached to the side of the reservoir. ( about $14. 00 at Autozone Part # 22138719 ) Note: there is also a relay that may be bad.
How do you replace the windshield washer reservoir on sienna?
To replace the window washer reservoir, you must first locate the reservoir under the hood, usually along the side fender area. (You can follow the rubber hose that is attached to the spray nozzle down to your reservoir). Now detach the two wires connected to the little pump motor inside the reservoir, and any bolts securing the reservoir to your car. You may need to look for the bolts. Take your time, figure out how the thing is secured, and get er out of there. If the thing is buried, you may have to remove another part to get to the reservoir. If this is the case, take your time (maybe take a picture), keep track of your nuts and bolts, and keep with it. Good Luck
How do you change a windshield washer pump on a Cutlass Supreme 93?
I recently had to put a washer fluid bottle and washer pump in a 1992 Cutlass Supreme convertible that I purchased. I believe the 1993 is the same. The windshield washer pump mounts vertically on the back side of the windshield washer fluid bottle. You will likely have to remove the brace on the driver's side, and the two nuts holding the left side fuse block to the fender. You will also have to undo the positive battery terminal. Undo the two clips holding the washer reservoir at the front. Start to lift the washer reservoir out, and you should see the hose that is connected at the back rear of the reservoir. You can unclip the hose using a long flat head screwdriver. You should be able to see the washer pump mounted vertically at the rear of the bottle. Unclip the electrical connector and you can pull the pump straight up out of the bottle. I found a washer reservoir and a washer pump at a "U-Pick" scrapyard and believe that I paid $5.00 for both and they worked great. The washer bottle came out of a Lumina, the washer pump from a Sunfire and I noticed that it had the same part number on it as the one in my Cutlass. Once I had all that back together, I wasn't getting any fluid on the windshield, but noticed some running in the cowling at the bottom of the windshield. The lines were disconnected under the cowling, and by removing the panel at the bottom of the windshield, I was able to reconnect it. Good Luck, Kevin Baillie (Two 1992 Cutlass Supreme Convertibles, one 1994 Cutlass Convertible, and a 1994 Cutlass Ciera)
Where to buy windshield washer fluid?
Auto part stores, Walmart, Target, gas stations.
Where is rear windshield washer pump on 2004 Tahoe?
Attached to the lower part of the fluid tank.
How do you repair a 98 Honda CR-V windshield washer system?
More information please. Which part of the system. The wipers? The wiper arms? The linkage conecting the wiper arms to the motor? The motor? The windshield washers? Windshield washer pump? Etc? Please be more specific.
What is the location of windshield washer pump for 1990 Acura Integra?
front right part of the under the hood
How do you change the washer pump in a galant?
I have a Mits Galant 1990 A/T and recently repaired a leaking washer pump. The washer pump in my Galant is attached to the lower part of the water reservoir. You need to remove the electrical connection to the pump and remove the reservoir. Afterwards, you can remove the washer pump and replace it with a new one. To ensure you have no leaks when you install the new pump, I suggest you line the holw of the reservoir (the hole where the pump goes into reservoir) with silicone paste or any other sealant. Replace the reservoir and the connect the electrical connection.
Windshield washer fluid level light on Mercedes C220?
In most cases it is probably just the level sensor, which is located in the washer tank. Fairly cheap part I think
Where is the washer pump on a 1989 Buick Riviera?
Its part of the windshield wiper motor assembly. It unsnaps from the assembly for EASY replacement!
