You close the 2 shut off valves below the faucet, remove the pipes going to faucet from both ends. Now you will see the 2 large flat nuts holding the faucet to countertop. These will be easier to remove with a plumbers faucet wrench (about $8 in your hardware store) This has a long shaft and a flat spring loaded head. Remove both nuts and pull faucet out. When you go th get new faucet,also buy braided SS flexible water lines. About $4 each, they are much simpler and better than the cheap grey plastic ones. Re-connect everything opposite order.
1. Replace the pipe, 2. Shut off the water
1- plugged shower head 2- defective diverter
Go To www.nclicensing.org Download theLicensing application form, An applicant must have 2 years xperience in the installation, maintenance, service, or repair of plumbing or heating systems related to the category for which license is sought,
I'm assuming you have a some kind of a leak. The problem is usually caused by something called a seat. It looks like a washer; but, it's not. Because it has a square access You might need to purchase a "Faucet Valve Seat Wrench". It looks like the letter L Most hardware places will carry one. I got mine at Home Depot's. I will add more to this later. It took me months to figure what those extra washers were that came with the valve stems were. They didn't include instructions or anything.
Depends how leaky it is, but if you are on a well, any leak is critical.
That is nearly 2 gallons an hour - time to fix that faucet
The most obvious step to fixing a leaky faucet is to turn off the water supply to the sink. That being said, another "first step" would be to know exactly what type of faucet is to be repaired.
You can replace the rubber gasket.
Sure. No problem. It's a relatively fast leak, but it's only 2/3 of an ounce per minute.
You have a new one installed!ANS 2 - Usually very easy to fit a new faucet, even directly to a pipe. -Many faucets now come with a compression fitting.
what is the GPM rating from the old to the new the lower the GPM the slower the water. Sometimes there are restrictor discs (washers).
Just change it. There are still hot and cold connections underneath and all kitchen faucets fit the same holes in the sink.ANS 2 - Very easy to fit another faucet, all you need is basic handyman skills, a plumbers faucet wrench (sometimes) a medium crescent wench and a 9/16 flat wrench. Takes about 30 minutes.
If the blade has a section that slides into the handle, I would use a 2 part epoxy glue on it. Instruction with the glue. If it has broken clean where the blade meets the handle, there is really not much that can be done. It can be welded, but it would always show the repair.
FAUCET ['fɔ:sit] 1. чеп, канелка, тапа 2. кран (на чешма), винтил
Clean the screen in the end of the spout.
silicone caulkI fixed mine with some silicone caulk like you would use for bathroom repairs- worked fine after that ANS 2 -Depends where the leak is ! -You don't say. If the leak is from the door as many are, then you need a new door seal. -If from somewhere underneath, you need to pinpoint it and repair that exact part. Often the drain hose right at pump fractures, or it may be the pump itself. -You must narrow down the location !