Want this question answered?
the brake fluid level is low in your master cylinder, add some brake fluid and the light will stay off
put it in .. der
HOW DO I RESET THE PAD WARNING LIGHT ON MY RANGE ROVER
If I understand your post: The brake light is on constantly? If so, you may want to adjust or replace the brake light switch located at the top of the brake pedal.
Probably cause by a worn out/defective brake light switch.
take the old one out then put a new one in
Must be done by the dealers diagnostic machine
Check to see if Brake lamps work when brake pedal is pressed. If not gear shifter is locked for safety so replace fuse or repair brake lamp switch.
There could be many causes to a brake light not working. It is best to replace the fuse, and the bulb and check the wiring.
THIS VEHICLE THROWS A CODE WHEN ELECTRONIC WEAR SENSOR HITS ROTOR, CAUSING MESSAGE "CHECK BRAKE LINING", AND BRAKE LIGHT TO COME ON. THIS CODE MUST BE CLEARED IN VEHICLES COMPUTER BY OBD II OR EQUIV.
Check your brake fluid. You may need to replace a speed sensor on one of the brake assemblies.
Pry the the unit holding bulbs away from the car by squeezing and levering from the top.