In order to repair a crack in a plastic playground slide, on should obtain a certain amount of superglue, tape, and paint. The superglue can be used to fill in the crack with a solidifying substance, and the tape can cover it. The paint makes it look like new.
If the hole is big, place a netting of some sort over the hole first. I used a piece of very thin fabric ribbon. Adhere it with a little plastic epoxy. Spread PLASTIC EPOXY over the top of ribbon covering the hole and smooth it. You can pick this up online or maybe even at Home Depot. Plastic epoxy is what they use for plastic car bumper repairs. Smooth it with a putty knife. Let cure. Spray paint with paint FOR PLASTIC if you want it colored.
Put Duck Tap
i dont have one you .....r you dont no enny mour then me so ...k off you ....er john cowan
Most plastic 'glues' will melt the plastic enough to fill in a small hole. You may want to supplement it with another piece of plastic.
1st hole=3rd slide 2nd hole=6th slide 3rd hole=2nd slide 4th hole=5th slide 5 hole=4th slide 6th hole=1st slide
YOu can actually purchase a tent repair kit to fit your needs at most sporting good stores.
There is no safe way to repair a plastic fuel tank, you must replace it.
You can repair it with a welder or you can replace it.
You have to go to the playground and then dig the hole close to the girls standing. Hopethis helps
To get under the playground you have to use the crackers to bring the dog over to dig the hole. After this you will find the time capsule and Nate will take the credit.
open the trunk and take the black plastic cover off from the top of the tail light (it just pulls of) undo the one screw on the top and then slide the hole tail light to the outside of the car and the clips should all slide out.
helicoil
A small nail hole can be fixed with a self tapping screw screwed into the hole. If you can turn the water off and it is a copper pipe you can also solder the screw in place. This would also work for a plastic pipe. You may need to seal it with a silicone gel similar to those products that seal around a bath. Otherwise cut pipe in half and get a compression coupling or flexible pipe repair section from Screwfix.com in the UK.
according to a Chrysler technical bulletin on this issue you need to drill a small hole in the top center of the plastic housing that surrounds the headlight. this will allow moisture out.
cone method,deep hole method,slide hole method,center hole method,trench method,slit method