Yopu have to take the whole unit out.. removes seats.. panels undo 10 mm bolts.. disconnect power lead to window motor.. etc..
What you find with these motors is that they seize up.. just undo the motor from the rotor assy.. free off the motor.. and text it on a bench.. it should work..
Next.. add a good dose off 3 in 1 oil into rotor assy windingsthis should help free the windings.. they seize because where they sit in the window well they get wet.. or cold and the grease solidifies etc..
->> usually only the Lebarons rear window motores up to 1990 got wet, the newer ones hat other problems:
no.. very different.. by hard top you mean 4 door..?.. the 4 door window mech is a scissors action.... the convert is on a frame and cabled..
The first step on how to change the motor on a 1992 Chrysler LeBaron V6 3.0l is to position the vehicle to where you can get the hoist in and out.
No. They are not interchangeable.
It is behind the rear seat.
i need to learn how to take out my 1995 Chrysler lebaron convertible motor
I was just searching the list and there is an answer to a similar question already in FAQ
The wiper motor on a 1992 Chrysler LeBaron won't work if the motor has seized up or the fuse has blown. The switch inside the cabin or the wiring can also come loose and cause this problem.
the fender probably fills up with water. You need to make sure that the drain holes under the car are open. this shorts out the motors. then you need to access the motor and have it rebuilt or find a used one.
2.5l four cylinder or a 3.0l v6
in the trunk.. upper right side...
No.
Top center passenger side