answersLogoWhite

0


Best Answer

My guess is that you unscrew the plastic panel of the dash board below the steering wheel. Then you unscrew the two screws that hold the brace that supports the bottom of the steering wheel. this will allow the steering wheel to fall down a little. Then you reach far under the steering wheel down by the pedals and remove the screws for that other brace that is right at the bottom. there are at least 6 this will allow the steering wheel to lower even more. Then you carefully remove the plastic end of the cable that fits onto the nipple at the steering wheel. Don't ruin it . Don't stretch it any more than you have to.

Then you move forward along the cable and remove the staple like cotter pin thing from that device that the cable runs through. Then you squeeze together the little tabs on the collar of the cable that is rear ( towards you ) of that device, and once they are squeezed feed the cable and collar through the device towards the front of the van. That is as far as i got. Next i would think that you could maybe remove the part of the cable that gets wider, or maybe it will fit throught the firewall. Or maybe just widen the hole in the firewall. then feed it through the area under the hood, and pop that part that attaches to the bulkhead out , and then remove it from the brace it runs through near the trans by removing another staple like cotter pin.then unscrew the screw on the post that comes out of the trans. DON't try to pop off the plastic from the nipple on this end. YOu will ruin it. It will pop off while driving then. just leave the freaking metal arm on it and have the ... Oh wait you want to repair it, so you have to get a new one anyway. So i guess its ok to ruin it. i don't know. i am getting tired of this shit. Also there is some white plastic pin near that brace but i dont think it is worth taking off. i could not find any apparant way of removing the little metal rods from the more flexible portions of the cable. Even after taking that white plastic thing out.

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you repair shift cable on a 1995 Chevy G-20 van free diagram?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace automatic gear-shift cable 2000 corolla?

I need to repair the gear shift cable in side a 2000 toyota corolla. How do you get in side the gear shift box to repair the cable end?


How do you repair the connector on a gear shift cable?

Usually, the complete cable must be replaced.


Diagram of Cable from shift lever to shift linkage that controls the selection of the gears in automatic transmission vehicles?

yes


How do you fix a broke shift cable on a 1998 Kia Sephia?

purchase a replacement cable and install it. its not reccomended to repair a broken cable


How do you get 1996 Chevy s 10 to shift out of park?

The cable between the shift lever and the transmission may be bad.


How do you replace a 2005 Chevy Trailblazer shift cable?

Buy the Cable , then remove the screws that hold the broken cable and attach the new cable back.


How do you replace shift cable for 01 cavalier?

The shift cable on an 01 Chevy Cavalier is replaced by removing the retaining screws, removing the cable from the shifter, and pulling it from the vehicle. A new cable can then be locked into place and bolted down.


How will it cost to repair the gear shift linkage in a Chevy Trailblazer?

I live in Forest Park, Ga, and my gear shift got stuck and would not move, had it checked out and it was the gear shift cable, the price at Hessessy Pontiac was $85.00 but i found it at Terrry Cullen Chevrolet for $66.00 and $30.00 to install...


Where is the transmission linkage located on a 1987 Chevy Celebrity?

The transmission uses a cable for linkage. If the car has consol shift the cable runs from the shifter to the transaxle. If it is a column shift the cable runs from a lever on the column to the transaxle.


Why want s-10 Chevy come out of park?

I have seen the shift cable rot and go bad under the drivers floor carpeting causing the shift cable to freeze up and not let you operate the shift selector.


Car runs but wont shift in gear to drive . 2000 Chevy Malibu 3.1?

check shift cable to transmission,it is either broke or stretched out !!!!


1997 Chevy Lumina repair manual?

transmission wont shift from low to high very good