Turn siganl switch is bad or faulty. bad news, this is a dealer item only, which means $$$, but you can get one out of a junk yard for a fraction of the price. If the switch will switch up or down, check your light bulbs first. If it acts like it's jammed, you need a new or used turn siganl switch.
There is a problem with the SRS system. Take it to the dealer for immediate service. Do not atttempt to repair this yourself. This is not a DIY repair.
Seek professional help as there is a problem with the SRS. This is not a DIY repair.
There is a problem with the SRS. Take it to a professional, for repair.
If the check engine light flashes an engine cylinder misfire has been detected Avoid any heavy acceleration / decelleration and have the vehicle scanned for any trouble code(s) in order to diagnose and repair the problem
Well, i had this problem. Most likely the ecu. Try pulling on the wires to see there is no short. That's what ford repair guy did started in no time cost me £60.
There is a problem with the SRS. Take it to a professional and do not attempt to repair yourself. Serious injury can occur if repaired incorrectly and the air bag deploys prematurely.
I had the same problem and it turned into a huge repair bill replacing the manifold and fuel injectors.
It sounds like you have a power supply problem. The capacitors on the switched mode power supply have changed value or failed completely. Replace or repair the power supply section.
There is a problem with the SRS. Take it to a professional for repair. This is not a DIY repair.There is a problem with the SRS. Take it to a professional for repair. This is not a DIY repair.
The only perfect way to repair a tile with a hole in it is to replace it. The second best way is to simply fill the hole with grout. This isn't a pretty repair, especially on dark colored tile, but it will at least stop water from getting behind the tile and turning a small problem into a large problem.
It is on because the ECU has detected a problem with the emissions system. Take it to a professional for repair of the problem. He will reset the light after the repair.It is on because the ECU has detected a problem with the emissions system. Take it to a professional for repair of the problem. He will reset the light after the repair.
Repair the problem.