This is probably one of the most tedious and painstaking things I have done on my 2500. First of all remove ALL the door panels, you should see an oval in the door right where a window crank handle would go, the motor is bolted to the back of this by either one nut and two bolts or one bolt and two nuts which you can barely see, you have to remove these (the painstaking part) and push the motor away from the mechansim, keep in mind that you have to secure the window before removing the motor or it will drop once the motor is removed and could cause damage to both the window and your arm!
power window motor removal 93 sunbird
My 93' vandura has a 5.7 liter 350cubic inch engine.
hydromatic 400
check your fuses, if not, replace the window motor located in the door.
To replace the window motor in a 1993 Toyota Camry, first, disconnect the negative battery cable to ensure safety. Remove the door panel by unscrewing any screws and gently prying it off to access the window motor. Disconnect the wiring harness from the old motor, unbolt it from the door, and then install the new motor by reversing the steps. Finally, reattach the door panel, ensuring everything is secured and reconnect the battery.
You will have to remove the door panel and replace the regulator assembly. In some cases it comes as an assembly with the motor.
To replace the window motor in a 1993 Pontiac Grand Prix LE, start by removing the door panel to access the motor. Disconnect the wiring harness from the old motor, then unbolt it from the door frame. Install the new motor by securing it in place and reconnecting the wiring harness, then reassemble the door panel. Test the window to ensure it operates correctly before finishing up.
Yes I do. would you like it faxed or e-mailed?
The outer and inner door panels on the door must come off. FRom there you have access to the rivets holding the motor to the door. Break the rivets and replace with the new motor. The new motor should come with bolts if from the dealer.
1993 Vandura motor sizeGet VIN number from the vehicle, call your local Chevy dealer parts department, and he can identify which engine is in your vehicle from the VIN. They usually had a 5.0 liter(305 cu.in.), 5.7 liter(350 cu.in.), which was most common, and a diesel was available. *My 93' Vandura has a 5.7*
Most likely the window motor is dieing. If you want to replace it you can. It is not easy but it is possible to fix. Remove the door panel. Find the motor and drill out the rivets or get the old motor out by any means necessary. Unplug the motor Bolt in your new window motor and plug it back it. Before you replace the door panel, turn your car back on and make sure that the window motor is working. If it works replace the door panel. If not check the fit of the motor and the wiring. takes about 3 hours your first time if you have all the tools you need and know how to get the door panel off.
there are actually 3 fuses ( that i have found) 2 are in the fuse panel below and to the left of the steering column marked ac and auxilary ac/heat. my 1993 g3500 vandura also has an inline 20 amp fuse wired in between the fuse panel and the rear blower motor switch.