Want this question answered?
The ignition switch is part of the WCM (wireless control module).The ignition switch is part of the WCM (wireless control module).
Behind instrument panel trim.
It is a possibility.
where is coil d located on 2006 toyota avalon
remove the front cover, disconnect the turn signals wires and the two nuts that whole the gages, then down under the ignition switch and remove the two Allen screws and disconnect the wiring. install your new one ignition switch in reverse to the instructions.
Possible bad ignition switch
ow to replace brack light switch 2006 cadillac cts
you should be able to find a shop manual at the local library with the right information on this -- make copies of the pages, as they are usually for REFERENCE only...:)
May be a defective ignition switch
...everyone should have a manual for their vehicle(parts store or dealer), and a local library should have professional shop manuals available in the REFERENCE section for free...make copies of the appropriate sections...read up and good luck :)
Detroit Ignition was created in 2006.
The instructions on in the book that came with the van. Customer Key Programming You can program new sentry keys to the system if you have two valid sentry keys by performing the following procedure: 1. Cut the additional Sentry Key Transponder blank(s) to match the ignition switch lock cylinder key code. 2. Insert the first valid key into the ignition switch and turn the ignition switch ON for at least 3 seconds but no longer than 15 seconds. Turn the ignition switch OFF and remove the first key. 3. Insert the second valid key and turn the ignition switch ON within 15 seconds. After ten seconds a chime will sound and the Theft Alarm Light will begin to flash. Turn the ignition switch OFF and remove the second key.