First, lower window approximately half way. This allows you access to the bolts that attach window to the regulator. Remove door panel. Using a 10mm wrench, remove the two bolts that hold window to the regulator. Then there are two upper and two lower bolts holding the regulator to the door. Then you remove the three bolts for the window motor which is toward the front of the door. You have to also disconnect the plug for the windo motor to remove the entire window regulator and motr that are all one unit.
Replace the unit in the reverse way.
To replace a 2001 Ford Focus window regulator, first, remove the door panel by unscrewing and unclipping it to access the regulator. Disconnect the window from the regulator, then unbolt the old regulator from the door. Install the new regulator in reverse order, reconnect the window, and reassemble the door panel. Finally, test the window operation before securing everything in place.
To install a new window regulator on a MGRZ driver's door, remove the door panel and the wiring attached to the power window mechanism. Remove stereo speaker from the inside door and the window glass. Remove the old window regulator and replace with new.
To replace a rear window regulator on 2005 CTS Cadillac remove the side protection panel of the car door then adjust the regulator.
Window regulator controls the up and down motions of your car window. Both electric and manual windows have a window regulator. Not the easiest part to replace, but once you dissembled the door panel it should be fairly simple to replace.
undo the glass from the regulator and pull it up out of the door and get new gass and drop it down inside the door into the window channels and rehook the glass to the regulator.
It is easy to replace the window regulator or window clips on the rear window of a 2000 Grand Am. The clips simply snap right onto the rails inside that door that connect to the window.
First you need to remove the door panel.Then remove the door handle bracket.Peel back the moisture shield.Tape the window into place,then unbolt the window from the regulator.Remove the window regulator from the access hole in the door.
To replace the window regulator on a 1994 Thunderbird, first, remove the door panel by unscrewing any fasteners and carefully prying it away from the door. Disconnect the electrical connectors and remove the window crank or switch, then support the window in the closed position. Next, unbolt the old regulator from the door and carefully detach it from the window. Install the new regulator by reversing the steps, ensuring everything is securely reattached before replacing the door panel.
To replace the window regulator on a 1986 Monte Carlo, first, remove the door panel by unscrewing any fasteners and carefully prying it off. After accessing the regulator, disconnect the window from the regulator arms and remove any bolts securing the regulator to the door frame. Pull out the old regulator and install the new one, reattaching the window and securing everything back in place before reinstalling the door panel. Finally, test the window to ensure proper operation.
Take your door panel off and replace them...
The way that replace a window regulator in a 2003 Buick LeSabre front drive side is by removing the door panel. Next, disconnect the electrical connector on the regulator and replace.
Take the door panel off,you will need to remove 3 bolts for the window motor and then 3bolts(maybe4) that hold the regulator to the window